The take-off for an 8-inch butt weld elbow typically refers to the length of pipe that is required to accommodate the elbow's angle and diameter when calculating pipe runs. For a standard 90-degree elbow, the take-off is generally about 8 inches plus the radius of the elbow, which is typically 10 inches for an 8-inch elbow, resulting in a total take-off of approximately 18 inches. For other angles (like 45 degrees), the take-off measurements would differ accordingly. Always consult specific piping codes or standards for precise measurements.
A butt weld is where the diameter of the pipes welded together are the same, a socket weld is where a larger diameter pipe is fitted into a smaller one. In making a butt weld, the pipes (or pipe and fitting) usually have an angle machined or ground into the outside corner, so when they are placed together face-face, there is a circumferential V shaped gap serving as the weld prep. In a socket weld, the pipe is inserted into the socket, backed off slightly to make a gap between the end of the pipe and the bottom of the socket, and the weld is made around the outside diameter of the socket to the outside diameter of the pipe. The gap at the bottom of the pipe prevents thermal expansion from stressing the joint during or after welding.
To calculate elbow take off in aerodynamics, you typically measure the angle of the elbow from the airfoil and its distance from the leading edge of the wing. This information is used to determine the change in lift and drag forces at different angles of attack. Elbow take off is important for understanding the aerodynamic performance of aircraft components.
The take-off for a 30-degree elbow can be calculated using the formula: Take-off = Pipe Diameter × 0.577. For example, if the pipe diameter is 4 inches, the take-off would be 4 × 0.577 = 2.308 inches. This formula helps determine the horizontal run of the pipe after the elbow joint.
take your filter off on google and type in girls butt
39in.
What it's the take out off 12 inch 90
The take off formula of a 45 degree elbow pipe, will depend on what the pipe is on. Sometimes a 45 degree pipe will need a 90 degree right angle turn to come off.
2 inches
1-13/16"= The tangent of half the degree X the radius of the elbow.
In the area of industrial pipe fittings: Long radius 90 deg elbow has a take off dimension of one and one half times the nominal diameter of the pipe. Ex-4 inch pipe has an actual diameter of 4.5, for the elbow the take off dimension would be 4"*1.5=6". The short radius elbow take off dimension is the same as the nominal size, 4". To add to the point, a short radius elbow can be used typically where space is a constraint. Hence fluid flow is also restricted in this case unlike in case using of Long Elbow.
nope, just take off your intake elbow(rubber piece ) and its right on the top of the water pump
Measure to the center of the Ell and decuct for the threads ..