0
It depends on the roof load and the actual clear span. Off hand, I would guess htat you haven't given this much thought. A rule of thumb for a steel truss is one inch per foot of span or in your case 40 inches. If you want to use a steel I-beam, you can get that from a good municipal library from the steel beam institute, but you are going to need a crane to place it.
Dieter in Cincinnati
What else can I help you with?
What size of beam is needed to span 10 feet if used only for roof support?
The size of the beam needed to span 10 feet for roof support depends on various factors, including the type of material (wood, steel, etc.), the load it will carry, and local building codes. For a typical wooden beam, a common choice might be a 2x10 or 2x12, but calculations based on specific load requirements and spacing are essential. It's advisable to consult a structural engineer or local building codes to determine the exact specifications for safety and compliance.
To remove 8 feet of load bearing wall and replace with steel beam what size beam?
With a span of only 8" you can probably use a wood beam, but without a set of plans no one can accurately answer your question.
What are the uses of cantilever beams in real life?
A cantilever beam is often used for making balconies in residential architecture. A cantilever beam is a beam that is supported only one of its ends while the open end can support a certain weight.
How many reactions are offered by a roller support?
In 2 dimensional beam analysis, only one reaction force normal to the roller. The beam is free to translate sideways and rotate without restraint
Who and who gave Columbus the needed support for his trip west?
Columbus's wife was there to support him. Cause, he knew that she was the one who only took him seriously.
What is the length of a olympic gymnastics balance beam?
The length of any competitive balance beam is 16 ft. Depending on the age and competitive level, the height of the beam can be adjusted. At the high school level the height is approximately 4 ft.
How many squares of shingles are needed for a roof 28 feet by 60 feet?
16.8 Square, but, you can only purchase full square packages
5. You should only use your high-beam highlights when there is no oncoming traffic for at least feet.?
You should only use your high-beam headlights when there is no oncoming traffic for at least 500 feet. This helps prevent blinding other drivers and ensures safe visibility for both you and others on the road. Always switch back to low beams when approaching another vehicle to maintain safety.
Does a 4 X 8 X 16 steel beam need a center support when it has only one floor level that it supports. The room it supports is 16.5 foot wide?
you should be fine if you are just supporting the load of the floor. If you are putting increased load on the beam to support the roof somehow that could be a problem.
Why does only one high-beam work?
A possible reason that only one high-beam will work is that the malfunctioning bulb is burnt out.
Why does the left headlight of a 1995 Mercury Villager only work on high beam only?
The low beam portion has likely burned out
Why is the warren truss bridge so strong?
It involves a configuration the combines strength and productivity. The designing uses SAE steel grades (essentially an amalgamation of carbon and alloy steels) which renders the framework strong yet complex. It ensures that any beam, strut or tie ends only undergo tensional or compressional forces.
