answersLogoWhite

0

If you mean stop/ stick while cutting /

the saw might be too small for the job. required.

The blade could be blunt.

Very wet timber can jamb the blade.

One tip is to cut a wedge hit this in at the rear of the timber

after the timber has passed through the saw about a foot.

AT ALL TIMES KEEP HANDS CLEAR OF SAW BLADE.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Why must saw teeth be set?

The set on the teeth makes the kerf (width of the cut) slightly wider then the blade so the saw can clear the dust from the cut and the blade won't bind up.


The path a saw blade cuts in a piece of wood is called what?

"kerf" cut. Rabbet? Dado? Or just the cut line? Your question is a bit vague as to what type of cut. Kerf is the alternating offset of saw blade teeth. It provides the clearance needed to make room for the rest of the blade to pass through, otherwise it would bind in the cut.


What type of saw blade would you use in a circular saw for cutting a quarter inch backer board?

a concrete or masonry blade


Why is a tenon saw's teeth bent from side to side?

It is called "set" in the teeth. It takes a the sawdust out of the cutting surface so the saw will not bind as much.


How do you choose the right saw blade?

There are many kinds saw blade, diamond saw blade and carbide saw blade. You should choose the saw blade according to the application, like wood, metal, stone, concrete, wall and so on.


To make a wide groove in a board with a table saw what type of blade would you use?

A dado blade. A dado blade is 2 saw blades sandwiched around a number of "chisel" blades added or subtracted to achieve the desired width of the saw cut.


How do you change a DeWalt circular saw blade?

To change a DeWalt circular saw blade, first unplug the saw for safety. Then, loosen the blade nut with a wrench and remove the old blade. Place the new blade onto the saw, making sure the teeth face in the right direction. Tighten the blade nut securely and plug the saw back in.


Does the manufacturing logo on a circular saw blade always face out toward you?

Depends on the manufacturer and if the saw is left or right handed. Normally a saw cuts UP rotating in the opposite direction a wheel would. Click the saw on, without a blade in to see which way the motor turns then put the blade in to cut in that direction.


How can I effectively maintain and sharpen my miter saw blade using a miter saw blade sharpener?

To effectively maintain and sharpen your miter saw blade using a miter saw blade sharpener, follow these steps: Ensure the miter saw is unplugged and the blade is removed. Secure the blade in the sharpener according to the manufacturer's instructions. Use the sharpener to grind away any dull spots on the blade. Check the blade for sharpness and repeat the process if necessary. Reinstall the blade on the miter saw and test its cutting ability.


How can I safely and effectively sharpen a miter saw blade?

To safely and effectively sharpen a miter saw blade, follow these steps: Unplug the saw and remove the blade from the saw. Clean the blade with a degreaser and a wire brush. Use a blade sharpener or a file to sharpen the teeth of the blade. Ensure each tooth is sharpened at the same angle. Reassemble the blade onto the saw and test it before use.


The size of a portable circular saw is determined by?

The size is usually referenced by the largest diameter circular blade which would fit in the saw.


Can I use a larger blade on my circular saw?

No, it is not recommended to use a larger blade on your circular saw as it may not be compatible with the saw's design and could pose a safety risk. Stick to the recommended blade size for your saw.