with a little snipping there should be no problem. if you don't mind doing a little hand work. it's possible because i slapped 1999 yz 250 plastics on my 1990 yz 125.
Underneath the rear fender you will find a single bolt in the center. This is what holds your seat on.
The front number plate and fender will fit. The side number plates, rear fender and airboxes will not. The 2005 KTM bikes have the side number plates attached to the rear fender (all as one piece) the 2003 models have number plates that attach indiviually (not as one piece)
The trailer wiring kit is available from Jeep at about $125 and plugs into a wiring connector accessible through a panel in the left rear (inside) fender panel (behind the spare tire, near the left rear turn signal) with the trailer wiring harness routed through a grommet in the bottom of the compartment
Yes, a 1995 RM 125 motor can fit into a 1990 RM 125 frame, but there may be compatibility issues that need to be addressed, such as mounting points, wiring harness connections, and exhaust alignment. It's essential to check specific measurements and components, as well as potential modifications required for a proper fit. Overall, while it's feasible, careful consideration and adjustments may be necessary for a successful swap.
Chiquititas - 1995 5-125 is rated/received certificates of: Argentina:Atp
Chiquititas - 1995 6-125 is rated/received certificates of: Argentina:Atp
Chiquititas - 1995 2-125 is rated/received certificates of: Argentina:Atp
Chiquititas - 1995 3-125 is rated/received certificates of: Argentina:Atp
Chiquititas - 1995 4-125 is rated/received certificates of: Argentina:Atp
Dulce Ana - 1995 1-125 is rated/received certificates of: Argentina:Atp
The Kawasaki 1995 KX 125 will average 25 + miles depending on conditions and riding sytle j.james
with out a core its about $125