answersLogoWhite

0

It is not possible to Jump Start your Harley using the battery tender wiring harness.

The battery tender wiring harness has a 3amp inline fuse that will blow if you attempt to do this.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you Wire Harness for signals on a Harley Davidson?

please be more specific. what year, what model? schematics for wiring harness 2001 soft tail motorcycle


Were do you locate the wiring harness from the fuel pump to the battery on a 1989 dodge dynasty?

The Dodge Dynasty was produced from the years 1988 to 1993. The wiring harness from the fuel pump to the battery in a 1989 Dodge Dynasty is located very close to the battery terminals.


How do you replace the starter on a 98 Chrysler concord?

Disconnect the - battery cableRaise and support vehicleRemove wiring harness at starterRemove mounting boltsRemove starter Disconnect the - battery cableRaise and support vehicleRemove wiring harness at starterRemove mounting boltsRemove starter


How do you replace the wiring harness on a 1995 Pontiac Grand Am?

You should never have to replace the wiring harness, and if you do get a professional to do it. Now if you are talking about the wiring harness for a after market head unit, then you just buy an adapter. AND ALWAYS DISCONNECT THE NEGATIVE BATTERY CABLE WHEN MESSING WITH YOUR CARS ELECTRICAL SYSTEM.


How do you fix electrical wiring for brake lights for 91 chevey camaro when there is no current to the light bulb?

check wiring from battery to wiring harness to fuse (check fuse also) to harness to brake light. Check ground, too


On Harley Davidson softtail how to install device to run rear blinkers as taillights?

buy a module and install it inline in your wiring harness


Can bad wiring from a battery harness make fuel pump fuse blow?

Yes. Bad wiring can make any fuse blow


How do I connect the hardtop wiring harness?

To connect the hardtop wiring harness, first ensure that the vehicle's battery is disconnected for safety. Locate the wiring harness connectors under the hardtop and align them with the corresponding connectors on the vehicle. Firmly push the connectors together until they click into place, ensuring a secure connection. Finally, reconnect the vehicle's battery and test the electrical components to confirm proper functionality.


Where is the block heater cord on 1999 2500 Chevy?

Zip tied to the passengers side battery wiring harness.


Does a craftsman riding mower have a reset button?

NO, If it doesn't turn over check battery conections, make sure battery is charged, check all safety switches (under seat and on the deck handle) and if unsure follow wiring harness to the switches. Or may have a blown fuse in the wiring harness.


What would cause car gauges to shake?

COmputer, loose battery, defective battery/volt amps or loose wiring harness/ wires grounding out somewhere


How do I put in a new wiring harness for the voltage regulator on a 1990 mercury topaz?

To install a new wiring harness for the voltage regulator on a 1990 Mercury Topaz, first, disconnect the battery to ensure safety. Remove the old harness by detaching the connectors from the voltage regulator and any securing clips. Connect the new wiring harness to the voltage regulator, ensuring all connections are secure and properly aligned. Finally, reconnect the battery and test the system to ensure the voltage regulator is functioning correctly.