Yes, obviously...
You take off the wheels bolts then, you put one side of each bolt in each peg and you enter the 2 bolts with the 2 pegs on it like before...
I only know how to put a deck on a madd gear pro but it should be the same on a razor. First you put the forks in then the handle bars.
ok my name is Matthew and i will be teaching you how to reinforce a madd gear scooter. 1) take off the white plastic covers at the back of the scooter next to the back wheel. 2) find a metal tube to fit/bits of metal and put it down the hole behind the plastic. 3) place a sheet of meatel to fit on the bottem of your deck and put plasict back on. 4) final go and ride your scooter.
you can shorten any scooter bars - but you need a saw. you just work out your length and cut of the bottom - make sure u put 2 slits in though or the bar will snap!
Yeah you can you can put it on any scooter
The clamp on a scooter gets put on the wheel
No
Because there is no need to. Why put gears on a scooter if you push not pedal?!
rubber
Scooter put a pin in Midway Island is a homework assignment in Grand Island. See link below.
u probally could but you might need to mould it
Cold