Yes you can,but only if it is used with a gravity feed system because clear vinyl tubing cannot hold much more than a few psi fuel pressure. Also,it may start to yellow and harden with todays fuels.
You can use clear tube for a fuel line but only when using a system that is fed by gravity. Any other type of fuel system will have too much pressure for the tubing to handle.
Approx. $5000.00 to $ 7000.00
Replace the damaged line and old fittings. If possible, use stainless steel tubing and fittings.
There is no safe way to repair a broken or leaking brake line. The line or tubing that is leaking must be replaced or a new piece of tube, spliced into the line with fittings, to replace the leaking area.
To remove drip line connectors, gently twist and pull them apart to disconnect the tubing. Be careful not to damage the tubing or connectors in the process.
A tubing nut.
The best way to connect a 1/4 inch copper tubing to a water supply line is by using a compression fitting. This fitting allows for a secure and leak-proof connection between the tubing and the water supply line.
I cut out the bad section of the plastic line. Bought rubber tubing at the Auto Parts store to fit the OD of the plastic line and plugged them together. It works fine.
To extend your refrigerator water line to a new location in your kitchen, you will need to purchase a longer water line tubing that is compatible with your refrigerator. Turn off the water supply, disconnect the existing water line, and connect the new tubing to reach the desired location. Make sure to secure the tubing properly to prevent leaks.
it should be inline. trace you fuel line back and you should run in to it, it should be silver or clear. if it is not in line, then it is in your tank.
every 96 hours
What size is the steel brake line tubing on a 1994 Ford Ranger