yes the crankshafts are the same
1997-2001
For a Ngk plug it is a: NGK DR8EA
1997-1999
On a 1997 Yamaha Warrior with the original frame it is located on the frame bar underneath the motor, and a few inches in front of it. If it has a replacement frame, it may not have a vin, because on a replacement frame they are supposed to be cut out of the original frame and welded to the frame bar underneath the rear fender on the passenger side of the quad.
Probably not.Yamaha changed these every 1-3 years so you would have to buy replacments from the dealer.Just because they look the same does not mean they are compatible with other electrical componets.
The 1997 Yamaha Warrior 350 has a length of approximately 78.3 inches, a width of about 47.6 inches, and a height of around 43.5 inches. The wheelbase measures 49.2 inches, and it typically has a seat height of 32.5 inches. The ATV is designed for rugged terrain, making it a popular choice for off-road enthusiasts.
i was told buy Ricky Stator for my 2000 Yamaha 350 warrior and i think its the same for yours is green to brown=300 ohms red to white=500 ohms its your stator, i had the same problem !!!!!!!!!!!!!!!!
NanoTek Warrior happened in 1997.
right side of crankshaft pulley
To adjust the timing on a 1997 Yamaha Warrior YFM350, first, ensure the engine is at top dead center (TDC) on the compression stroke. Remove the timing cover to access the timing marks on the flywheel and the ignition timing plate. Loosen the bolts on the timing plate, rotate it to align the timing marks as needed, and then tighten the bolts securely. Finally, recheck the timing to ensure it is correctly set before reassembling the cover.
The Secrets of the Warrior's Power - 1997 TV was released on: USA: 17 December 1997
yes