check battery, fuse and wire connections. heres a site just for Chinese atvs. http://chineseatv.webs.com/
the ground wire.
It control's the starter.
Just buy a new ATV, and your problem is fixed!
it is very easy only with 2 bolt and power wire
No its Chinese made.
The average price for a Chinese ATV can vary. Typically, the price range for a Chinese ATV can be anywhere between seven hundred dollars and eight hundred dollars.
Check to see if power is getting to the starter. If it is not check the solenoid contacts in it may be burned and not letting the power threw . If power is making it to the starter it maybe your brushes are in need of replacement or (dirt in starter ,broken magnets ,bearings or burnt wires).
To remove the starter from a 400 Honda ATV, first ensure the ATV is turned off and the battery is disconnected for safety. Locate the starter motor, usually found near the engine, and remove any covers if necessary. Disconnect the electrical connections and unbolt the starter from its mounting. Finally, gently pull the starter out from its housing.
If your ATV starts with a pull start but not with the electric starter, the issue may be related to the battery, starter motor, or electrical connections. The battery might be weak or not holding a charge, preventing it from supplying enough power to the starter. Additionally, there could be a problem with the starter relay, solenoid, or wiring, which could be interrupting the electrical flow. It's also worth checking the kill switch and any fuses that may be blown.
ATV Quad Power Racing was created on 2000-08-23.
To remove the starter from a 2005 Honda Rancher ATV, first disconnect the negative battery cable to prevent electrical shorts. Then, remove the starter cover by unscrewing the bolts securing it. Next, disconnect the electrical connections from the starter and remove the mounting bolts that hold the starter in place. Finally, pull the starter out from the engine casing.
I have a 1999 Yahama Blaster ATV. The ATV will only start when i spay starter fluid into the air filter, when i spray the starter fluid into the air filter it will only run for a short time. I have cleaned the carbraoter, and air filter seems to be in good working condition as well, the ATV also seems to have good compression.