answersLogoWhite

0

put a paper clip in and just turn until it starts

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you start a 1991 arctic cat snowmobile?

You put the key in & you turn it & it will start.


How do you start a Honda four wheeler?

Turn the key on. Put it in neutral and press in the start button.


Why does an Arctic Cat 500cc ATV keep blowing ignition fuses when you turn on the key to start?

Sounds like you have a wire grounded out somewhere in the wiring, possibly going to the switch.


Why does a 2002 Arctic Cat 500 auto ATV blow the ignition fuse when you turn on key to start?

I had the same problem and I took it in and it was the rear brake ground wire shorting out.


Can you put your vin number for your four wheeler on the key?

can i put my vin number of my four wheeler on my four wheeler key


Do Arctic CAt snowmobiles have the same key pattern?

Arctic Cat snowmobiles typically use a specific key pattern that is consistent across many of their models; however, there can be variations depending on the year and model. It's always best to check the owner’s manual or consult with a dealer for the specific key compatibility for your snowmobile. Some aftermarket options may also be available, but they might not fit all models.


How do you bypass a key in a 4 wheeler?

Burt


How do you get a key for a 1987 Honda 4 wheeler?

To get a key for a 1987 Honda four-wheeler, you can start by checking if you have the original key or its code, which may be found in the owner's manual. If the key is lost, you can contact a Honda dealer with your vehicle identification number (VIN) to request a replacement key. Alternatively, a locksmith experienced with motorcycles and ATVs may be able to create a new key based on the ignition lock. If needed, you might also consider replacing the ignition lock cylinder for a new key.


How do you start a 2002 Honda rancher 4 wheeler?

To start a 2002 Honda Rancher four-wheeler, ensure the vehicle is in neutral and the kill switch is in the "run" position. Turn the ignition key to the "on" position, then press the start button while squeezing the front brake lever. If the engine doesn't start, check the fuel level and battery condition. Once started, allow the engine to warm up before riding.


What drains a brand new battery on a 4 wheeler so fast?

leaving the lights on or if you keep the key in it like i do you might be leaving the key on.


How do you reset the belt light on a 2004 Arctic Cat 650 ATV?

To reset the belt light on a 2004 Arctic Cat 650 ATV, first ensure the engine is off. Then, turn the ignition key to the "On" position without starting the engine. Press and hold the red reset button, usually located on the dash, for a few seconds until the belt light turns off. Release the button, and the light should be reset.


Why does the starter for a four wheeler stay engaged when the key is off?

Starter solenoid is sticking. Replace it.