answersLogoWhite

0

What else can I help you with?

Related Questions

How do you adjust carb on 97 Polaris 400 4x4 2stroke?

Adjust carb on 400 Polaris 4x4 2stroke


How much horse power does the polaris sportsman 400 ho have?

29 hp taken from Polaris website. They have there 400 ho Ranger listed as 29hp and it has the same 455cc carb engine as the Sportsman 400 ho


How can you fix your 2005 polaris 500 sportsman that is getting gas in the oil?

Usually the float valve in the carb is bad . The valve will not stop the fuel and it runs down the cylinder into the crankcase .


1984 Mercury topaz has a high idol how do you adjust the idol?

"84 is still the carb. There is a small screw right at the throttle cable on the carb. Adjust that.


How do you adjust the carb on a 2000 Honda xr100?

there is a screw on the carb. be sure to adjust while the engine is running so you can tell by the idle when it is set properly.


What causes gas in oil on polaris 500 sportsman?

Bad float valve in carb


Where are the spark plugs on 2002 Polaris sportsman 700?

the spark plugs on a 2002 sportsman 700 is ontop of the motor behind the carb. remove the carb


What is the compression for a 1993 Polaris 250 Trail Boss?

I have a 1993 Polaris 250 Trail Boss. It won't start. It floods out the carb. Could it be low compression?


How do you adjust idle speed on 1983 Monte Carlo?

there is a set screw on the linkage on the carb that will adjust it.


Carburetor adjustment 2001 polaris trail boss 325?

You haven't really stated what you are trying to accomplish.there is a set screw on the bottom of the carb on your left as you are sitting on the quad you can adjust the idle up and down using this it changes how lean you are running.


How do you adjust carb float on a polaris sportsman 500 ho?

To adjust the carburetor float on a Polaris Sportsman 500 HO, first, remove the carburetor from the engine. Then, take off the float bowl to access the float mechanism. Adjust the float by bending the tab on the float arm so that it sits at the correct height, typically around 14-18mm from the gasket surface when the float is held parallel to the carburetor body. Finally, reassemble the carburetor and reinstall it on the ATV, ensuring all connections are secure.


Weber carb and its running too rich how do you adjust carb for an 87 samurai?

it's the screw right above the mounting bolt on the left rear of the carb. you'll have to adjust the idle screw as well as you lean it out. then check your timing again