0
What else can I help you with?
Point gap on a 1985 Honda xr100r?
It has electronic ignition. No points to adjust. 1985 Honda XR100R does have points and a condenser, just bought one today, and the gap is between12 and 14 thousandths
Are there points for a 1996 blazer?
If your speaking of ignition points, no. The last year that Chevrolet vehicles had ignition points was 1972.
What would couse A 1975 Honda gl 1000 goldwing to run only with the starter engaged?
If the bike has a "points" ignition system, check the starter circuit to see if it has an "ignition resistor bypass" to give a hotter spark when starting. This was pretty common on cars of that era. My 1975 Triumph motorcycle is set up with points and a bypass. Check the service manual (or do a visual by tracing wires backwards from the points) to see if the bike has a ballast resistor -- jump it to see if it will run and, if so, replace it.
The function of the condenser in a breaker points ignition system is to?
The function of the condenser in a breaker points ignition system is to keep the points from sticking together. If the points stick together during ignition it could cause the points to burn up. The condenser sends a signal to the points and then takes the signal away to make the points separate.
On a Chevrolet 350 does an electronic ignition have points?
No it does not have points or condenser.
Where are the points on a 1997 Kawasaki bayou 220?
Electronic ignition has no points.
How to clean 440 points?
Ignition points? You don't clean them. Replace them.
Does a 1988 Chevrolet G20 Van have points or an electronic ignition?
electronic ignition
Does a 1975 dodge dart 318 have points ignition?
It should have electronic ignition.
1975 Yamaha yz 80 points gap set?
To set the points gap on a 1975 Yamaha YZ 80, you'll want to adjust the ignition points to a gap of approximately 0. points to ensure proper ignition timing. This can typically be done by removing the flywheel and using a feeler gauge to measure the gap as you rotate the engine to the correct timing mark. Always refer to the specific service manual for exact specifications and procedures for your model.
How can i Change a dual pickup distributor to a points distributor on a 318 Chrysler motor?
To change a dual pickup distributor to a points distributor on a Chrysler 318 motor, first, remove the existing dual pickup distributor by disconnecting the ignition wires and the mounting bolt. Next, install the points distributor in the same position, ensuring it aligns properly with the camshaft. Connect the ignition wires according to the firing order and set the ignition timing as required. Finally, adjust the points for the correct gap and ensure everything is secured before starting the engine.
How do you change ignition points in a 1983 Honda 400?
Please describe your How do you change ignition points in a 1983 Honda 400 3F problem:
