0
What else can I help you with?
What is the fastest production motorcycle of 1985?
The fastest production motorcycle in 1985, backed up by the G. book of world records, was the 1985 Honda v65 Sabre.(1100 cc's)
1985 Honda V-30 Magna Motorcycle -What size of engine does it have?
500cc
How do you adjust the idle on a 1985 Honda Civic?
Idle on a 1985 Honda Civic is adjusted through a idle air control valve. This valve is located near the intake. Adjust the valve by either loosen or tightening it.
Bled clutch but 1984 Honda shadow still will not shift into gear?
http://en.allexperts.com/q/Motorcycle-Repair-837/1985-Honda-Shadow-Clutch.htm
Point gap on a 1985 Honda xr100r?
It has electronic ignition. No points to adjust. 1985 Honda XR100R does have points and a condenser, just bought one today, and the gap is between12 and 14 thousandths
Where can I find a 1984 Honda nighthawk 650 engine parts diagram?
www.bikebandit.com http://www.bikebandit.com/houseofmotorcycles/honda-motorcycle-cb650sc-nighthawk-650-1985/o/m9659
1985 Honda Accord?
It is a Honda Accord that was manufactured in 1985
What oil do you use for your 1985 Honda VT700C shadow motorcycle?
I have a 1986 Honda VT700 Shadow and it uses 10W 40 for most temperature climates. I would think that an '85 would take the same. Hope this helps
How much does the average motorcycle cost?
Very open question, new or used,what size,what make? 1985 Honda Magna.....$1700.00 2009 Harley Davidson....$28,000
What is the capacity and viscosity of oil for a 1985 Honda Fourtrax 250?
AnySE /SF rated10w30 or 10w40 (4 stroke motorcycle oil preferred). Holds about 2 litres...
What is the location of the main fuses on a 1985 Honda Shadow Motorcycle?
There are six Fuses for 1985 Honda Shadow : The main fuse (fusible link) is located above the voltage regulator/rectifier The cooling fan has an in line fuse and the remaining four fuses are located in the fuse panel between the speedometer and the tachometer.
How do you change out ignition cylinder 1985 Honda Nighthawk motorcycle?
Remove the switch by boring out the rivets holding it in place. The cylinder will come out easily once you get the lock free from its casing.
