answersLogoWhite

0

you take the q square and the s value and multiply by 169 to get the bolt loose. then eat a large hamburger. your welcome.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

How do you adjust the valves on a 2008 Yamaha ttr125?

valve settings on a 2008 yamaha ttr 125


How do you adjust the valves on a 2006 Yamaha Grizzly YFM125GV?

With great difficulty


What is a 2001 Yamaha ttr90 worth?

500 to 800 with gear and restored


How can you tell the year and model of a Yamaha dirt bike serial number jyacb03w6ya009925?

VIN: JYACB03W6YA009925 2000 Yamaha TTR90


How do you adjust valves on 2003 Yamaha Warrior 350?

With the engine at TOP DEAD CENTER (TDC) Adjust the exhuast valve to .007 and the intake to .005.


Yamaha TTR90 2005 mixed gas?

No, Just 91 octain or better it is a 4 stroke motor.


Need to know Fuel and air mixture setting from fully seated screws for a Yamaha ttr90?

For the Yamaha TTR90, the fuel and air mixture screw should typically be set at around 1.5 to 2 turns out from the fully seated position. This setting can vary slightly depending on altitude and other conditions, so it's advisable to start at this range and adjust as needed for optimal engine performance. Always ensure the engine is warm and running smoothly when making adjustments.


How do you put the throtle cable on the carby on a ttr90 Yamaha?

There is a hook on the end of the slide hook it onto the loop inside the carb.


How much oil is in a Yamaha ttr90?

The Yamaha TTR90 has an oil capacity of approximately 1.1 liters (or about 1.2 quarts) when including the oil filter. It's important to check the owner's manual for specific guidelines and recommendations regarding oil type and maintenance. Regular oil changes are essential for optimal performance and longevity of the engine.


How to adjust tapping valves?

You can adjust tapping valves by adjusting the lifters.


Where is the battery on a Yamaha TTR90 and how do I get to it?

The battery on a Yamaha TTR90 is located under the seat. To access it, you'll need to remove the seat by unscrewing the bolts or clips that hold it in place. Once the seat is removed, you can see the battery compartment, which is typically secured by a cover that may also require removal. After that, you can disconnect the battery terminals for maintenance or replacement.


How do you adjust carburertor on Yamaha fj1200?

how to adjust carburators on Yamaha fj 1200