0
How do you put the throtle cable on the carby on a ttr90 Yamaha?
Wiki User
∙ 14y ago
There is a hook on the end of the slide hook it onto the loop inside the carb.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is a 2001 Yamaha ttr90 worth?
500 to 800 with gear and restored
How can you tell the year and model of a Yamaha dirt bike serial number jyacb03w6ya009925?
VIN: JYACB03W6YA009925 2000 Yamaha TTR90
Yamaha TTR90 2005 mixed gas?
No, Just 91 octain or better it is a 4 stroke motor.
What is the pilot screw setting for a Yamaha ttr90?
The pilot screw setting should be screwed in until it is snug (not tight), then backed out 1 and 3/4 turns.
How fast will a Yamaha ttr90 go?
a 2007 model will take someone who weights 70 exacley 56kmph will a light kid like my brother who weights 30 it takes him around the 70 to 80 mark
Will a ttr90 beat a xr80 in a race?
No
Where can one find Honda CRF reviews?
You can find Honda CRF reviews in the Dirt Riders Magazines such as Yamaha TTR90 vs Honda CRF70 -Dirt Rider Magazine. in this Magazine you can find Information about Road riding Locations , Racing , News , Events and more about Honda CrF.
The dip stick broke off in your sons Yamaha ttr90 and there is a couple pieces that you cant get out - help?
I know nothing about the Yamaha TTR90 - but there exists a 'magnetic pickup tool' that might work for you if the pieces of dipstick will stick to a magnet . It is available from bike dealers and online. It is the size and shape of a slim pen that extends out to 12-18 inches. On one end is a small magnetized button. This is very useful for getting anything metallic from places too narrow to get your hand in, or off the garage floor if you are too lazy to bend down. In the UK it would cost a couple of pounds, so quite cheap. It will definitely go down the oil filler holes of any motorcycle.
How fast will a ttr90 go with a fmf pipe?
It goes exactly 5 to 222 in 2.2 secounds
How do you clean the carburetor on a Yamaha ttr-90?
I just cleaned my 03 ttr90 carb for the first time and it was pretty easy. First remove the seat and the rear fender plastic it gives you alot more room to work. Next turn the gas off and remove the fuel tank. tremove the two Allen wrench bolts holding it onto the motor and unscrew the air intake tube towards the front of the bike. Remove the choke cable and the throttle cable and unplug the two connectors on top of the carb. Drain the fuel out and unscrew the four bolts on the bottom (fuel bowl). Inside youll find the the two jets that get plugged. Unscrew them clean with carb cleaner and blow with air. Squirt all openings to clean. Make sure you don't loose the pin that holds the float to the carb like I did for alittle bit it is loose. Reinstall the jets don't over tighten and put the throttle cable and the choke cable back on (I found this to actually be the most difficult part its hard to get them lined up and make sure they work good. Reinstall the carb hook up all lines and while your there get a new fuel filter and replace it. Dont try to save money on the filter for there specially designed to fit in the tight space. (get it from Yamaha) This is the first time Ive done somthing like this and kind of enjoyed it.
What year is a Yamaha ttr90 with the VIN number JYACB03YX1A004931?
i found a web site the other day that showed me how to break down Yamaha vin numbers i do not remember the web site but it was saying that either the 2nd or 8th (i cant remember which one) numbers was the year y=2000 x=1999 w=1998 and so one now scince your 2nd and 8th numbers are the same it is probably a 2000. anything newer than a 2000 uses numbers instead of letters. I sell cars for a living. The tenth didgit from the left to right is the year. In the case of this serial #, this bike is a 2001.
You have a ttr90 that starts and runs at idle but when I attempt to feed it gas it starts to stall?
The carb main jet probably needs cleaning out, or the air filter is clogging up.
