Excess smoke from a Yamaha TTR90 can often be attributed to several factors, such as a worn piston or rings, which allows oil to seep into the combustion chamber. Additionally, using the wrong oil or an oil that is too thick can contribute to increased smoke, as can a dirty air filter that disrupts the air-fuel mixture. Lastly, improper carburetor adjustments may lead to an overly rich fuel mixture, causing excess smoke during operation. Regular maintenance and inspection can help identify and resolve these issues.
500 to 800 with gear and restored
VIN: JYACB03W6YA009925 2000 Yamaha TTR90
No, Just 91 octain or better it is a 4 stroke motor.
There is a hook on the end of the slide hook it onto the loop inside the carb.
The Yamaha TTR90 has an oil capacity of approximately 1.1 liters (or about 1.2 quarts) when including the oil filter. It's important to check the owner's manual for specific guidelines and recommendations regarding oil type and maintenance. Regular oil changes are essential for optimal performance and longevity of the engine.
The battery on a Yamaha TTR90 is located under the seat. To access it, you'll need to remove the seat by unscrewing the bolts or clips that hold it in place. Once the seat is removed, you can see the battery compartment, which is typically secured by a cover that may also require removal. After that, you can disconnect the battery terminals for maintenance or replacement.
The pilot screw setting should be screwed in until it is snug (not tight), then backed out 1 and 3/4 turns.
To remove the seat from a Yamaha TTR90, locate the bolts or fasteners securing the seat to the frame, typically found at the rear or under the seat. Use a suitable tool, like a socket wrench or screwdriver, to loosen and remove these fasteners. Once the bolts are removed, gently lift the seat upward and back to detach it from the bike. Ensure to keep the fasteners in a safe place for reinstallation.
Black smoke is usually from excess fuel. Blue smoke is usually from excess oil.
For the Yamaha TTR90, the fuel and air mixture screw should typically be set at around 1.5 to 2 turns out from the fully seated position. This setting can vary slightly depending on altitude and other conditions, so it's advisable to start at this range and adjust as needed for optimal engine performance. Always ensure the engine is warm and running smoothly when making adjustments.
Time for a rebuild
a 2007 model will take someone who weights 70 exacley 56kmph will a light kid like my brother who weights 30 it takes him around the 70 to 80 mark