To check the stator timing on a KTM 85, first remove the stator cover to access the stator plate. Align the timing mark on the flywheel with the pointer on the stator casing at the specified timing setting (usually around 2.0 mm BTDC). Use a dial gauge or a timing light to ensure the ignition timing is correct. Make any necessary adjustments by loosening the stator screws and rotating the stator plate, then recheck the timing before reassembling.
To set the timing on a 1996 KTM 250 SX, first, ensure the engine is at TDC (top dead center) on the compression stroke. Remove the flywheel cover and check the timing marks on the flywheel and the stator. Adjust the stator position by loosening the mounting bolts and rotating it until the marks align correctly. Finally, secure the stator in place and recheck the timing to ensure accuracy.
what oil is used in a ktm 65
no
my sons 05 ktm 65 sx has 5
No
To check the stator on a KTM 125, first ensure the bike is turned off and the battery is disconnected for safety. Remove the stator cover to access the stator assembly. Use a multimeter to measure the resistance between the stator's terminals; consult the service manual for the specific resistance values. Additionally, check for any signs of damage, such as burnt or frayed wires, and inspect the stator for any physical wear.
no it does not
To check the timing on a 50cc KTM, start by removing the spark plug and rotating the engine to top dead center (TDC) on the compression stroke. Use a timing light or alignment tool to ensure the timing marks on the flywheel and stator align correctly. If necessary, adjust the timing by loosening the stator and repositioning it to achieve the correct alignment. Always refer to the manufacturer's specifications for precise timing settings.
KTM 65 SX uses .5 L of Motorex Top Speed $T 15W50
the ktm 65 sx goes 60mph and its faster then the other 65s
sem same as older huskys used