oil plug location
3.3 quarts
add oil till full
The oil capacity for a Kawasaki Mule 3010 is 1.5 L, (1.6 US QTS. when filter is not removed)1.8 L when filter is removed. The oil levels should be between F & L lines on dipstick.
The Kawasaki Mule 3010 typically holds about 2.0 quarts (1.9 liters) of engine oil when equipped with an oil filter. If you're performing an oil change, it's essential to refer to the owner's manual for specific recommendations regarding oil type and maintenance intervals. Always check the dipstick after filling to ensure the correct oil level.
1.9 quarts or 1.8 litters with filter change 1.6 quarts or 1.5 litters with out filter removal
The oil fill location is under the seat. It is near the dip stick.
Yes, you can use synthetic oil in a 3010 Kawasaki Mule. Synthetic oils can provide better protection and performance, especially in extreme temperatures. However, always refer to the owner's manual for the recommended oil specifications and viscosity to ensure compatibility and optimal engine performance.
21/4-21/2
The filter # is napa gold 1394. This # can be cross referenced at any auto parts store. Joe
The recommended oil weight for the Kawasaki Mule 3010 Diesel is typically SAE 10W-40 or SAE 15W-40 engine oil. It's important to use oil that meets the API service classification of CF or higher. Always check the owner's manual for specific recommendations and maintenance guidelines to ensure optimal engine performance.
The Kawasaki Mule 3010 4x4 typically requires a high-quality gear oil with a viscosity of 80W-90 or an equivalent. It is important to use a gear oil that meets the API GL-4 or GL-5 specifications to ensure optimal performance and protection. Always refer to the owner's manual for specific recommendations and maintenance guidelines.
To change the oil on a Kawasaki Mule 3010, first ensure the vehicle is on a level surface and the engine is cool. Remove the oil drain plug and allow the old oil to fully drain into a container. Replace the drain plug, then remove the oil filter using an oil filter wrench, and install a new filter. Finally, refill the engine with the appropriate type and amount of new oil through the dipstick opening, checking the level to ensure it’s within the recommended range.