the battery is under the gas tank and really hard to replace. good lick.
All except the VROD models.
2010 VRod family.
Below the seat just in front of the rear wheel
Approximately 110 horsepower.
No, It will charge ok while connected in the motorcycle.
Yes, of course it does.
full charge should be 12.8-13volts
5...i'm forever looking for another gear...but, lo and behold, powerplant runs very strong with the present gearing
To charge a Harley Road King battery, first ensure the motorcycle is turned off and the key is removed. Connect a compatible battery charger to the battery terminals, ensuring the positive (red) lead connects to the positive terminal and the negative (black) lead to the negative terminal. Set the charger to the appropriate voltage and amperage for the battery, usually 12 volts, and allow it to charge fully. After charging, disconnect the charger in reverse order, starting with the negative lead.
battery removal of 2004 harley dyna
If it's a factory-installed sealed battery, charge it at 10 amps for 1 hour or charge it at 2 amps for 5 to 10 hours. If in doubt, use an automatic charger. For even better results, keep the bike on a battery tender whenever it's parked, which cannot overcharge the battery. A fully charged sealed Harley battery should read no less than 12.8 volts a minimum of two hours after charging. Any less voltage means the battery is failing and will eventually need to be replaced.
will be on right hand side in front of brake pedal , will have to remove right hand side radiator cover to gain access