0
Remove from the mc, disconnecting the ground cable first. Then hook up to a trickle charger at 10% the amp hour rating of the battery. Probably 2 amp. Charge fully, overnight is a good bet. Then load test the battery with an iron type load tester. Any auto parts store will usually do this for you at no charge. If it passes, reinstall battery in the mc reconnecting the ground cable LAST!! Then have fun riding. If the battery doesn't pass the load test, replace the battery new, and follow the previous charging procedure BEFORE you install into the bike. I dont care if it is "new" the battery had surely been sitting around waiting for you to come buy it. Recharge, install and ride away.
What else can I help you with?
Should you disconnect your Harley battery to charge it?
No, It will charge ok while connected in the motorcycle.
Does a harley sportster 1200 charge the battery when running?
Yes, of course it does.
What is the voltage of a 2008 Harley Davidson battery?
full charge should be 12.8-13volts
How do you charge a harley v-rod battery?
the battery is under the gas tank and really hard to replace. good lick.
How To charge a Harley road king battery?
To charge a Harley Road King battery, first ensure the motorcycle is turned off and the key is removed. Connect a compatible battery charger to the battery terminals, ensuring the positive (red) lead connects to the positive terminal and the negative (black) lead to the negative terminal. Set the charger to the appropriate voltage and amperage for the battery, usually 12 volts, and allow it to charge fully. After charging, disconnect the charger in reverse order, starting with the negative lead.
How do you remove the battery from a 2004 Harley dyna?
battery removal of 2004 harley dyna
How do you charge Harley battery?
If it's a factory-installed sealed battery, charge it at 10 amps for 1 hour or charge it at 2 amps for 5 to 10 hours. If in doubt, use an automatic charger. For even better results, keep the bike on a battery tender whenever it's parked, which cannot overcharge the battery. A fully charged sealed Harley battery should read no less than 12.8 volts a minimum of two hours after charging. Any less voltage means the battery is failing and will eventually need to be replaced.
How do you charge 2004 Harley sportster battery?
I just replaced a Harley battery with a YUASA, YTX20L-BS. It has the same construction, AGM, as the original, Harley battery. The charging information was on the top of the battery. It specified 13.00 volts as a full charge. A normal charge rate is 1.8A for 5 to 10 hrs. A quick charge is 9.0A for 1 hr. It is important not to let the battery get hot to the touch. Here are some useful websites: http://www.yuasabatteries.com/motor_battery.asp http://www.rversonline.org/ArtAGM.html Note the 14.0v maximum. Some auto chargers put an alternating current (AC) component on the output. You may wish to consider a charger designed for your battery to optimize its life. If you have accessories or an alarm make sure you don't need to disconnect them before charging the battery to prevent damage.
Where can one purchase a Harley Davidson battery?
There are a number of places where one can purchase a Harley Davidson battery. For instance, JP Cycles, Throttle Batteries, and Battery Mart all carry Harley Davidson batteries.
Does a battery cover for a 2006 harley nightster work for a 2006 Harley Sportster custom?
Yes, a battery cover for a 2006 Harley Nightster works perfectly for a 2006 Harley Sportster custom with a little fabrication.
Where is your battery on your harley?
Under the seat
Where is the battery on your harley?
Under the seat
