answersLogoWhite

0

The speedometer sensor is lovande On rop tight of the tranny, loosen The vilt and lift The sensor up, there should be a O-ring so be careful when you lift it up! then sand The sensor genre and clean it carefully. Done!

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How do you clean the chrome on your Harley Davidson?

Chrome Polish


How do you clean fuel injected system on Harley Davidson road king not start 3 years?

Sea foam works good. Spray or liquid.


What is the best way to clean a Kand N air filter used on Harley Davidson intakes?

With a KN filter cleaning kit. Simple and cheap. Get at any automotive store


What causes the speedometer to fluctuate radically while driving?

A bad/dirty vehicle speed sensor (vss) or bad wiring will cause this. the sensor is usually a magnetic pickup and any metallic dust stuck to it will affect the signal clean the sensor or get a new one


What is the best way to clean the mirrors on a Harley Davidson?

Use a soft cloth to clean the mirrors, and make sure to spray on some mirror cleaner. You will be able to pick up a mirror cleaner at your local supermarket. After it has been sprayed and wiped, use a dry cloth to wipe away any excess water.


How do you fix the speedometer on a 1991 Volvo 740?

If both speedometer and odometer do not work, usually the pulse signal are missing. E.g. the wiring coming from the rear differential where the sensor is located, can be deteriorated (broken or shorted). If speedometer only is inoperative, it is easiest to change the whole speedometer. To repair it, you need to be able to work on electronics, disassemble the speedometer unit, access the printed circuit board, and usually replace the leaking electrolytic capacitors on that board, as well as clean the circuit board of the electrolyte. Some other components may be broken also.


How do you check transmission fluid on 2001 harley Davidson ultra classic?

To check the transmission fluid on a 2001 Harley Davidson Ultra Classic, first ensure the motorcycle is on a level surface and the engine is warm. Locate the transmission dipstick, which is typically found on the right side of the transmission case. Remove the dipstick, wipe it clean, reinsert it without screwing it back in, and then remove it again to check the fluid level. The fluid should be within the marked range on the dipstick; if it's low, add the recommended type of transmission fluid as needed.


Can you clean an oxygen sensor on a dodge 5.9 360 magnum?

You can not successfully clean an oxygen sensor. You need to replace it.


How do you clean a FLAME SENSOR?

Clean it using steel wool.


WHY does Harley Davidson use belt drive?

Harley uses a belt instead of a chain because chains are messy, need constant adjustment, wear out sprockets and have a relatively short service life. A belt on the other hand is clean, rarely needs adjustment, is easy on sprockets and has a very long service life. 100,000 miles or more from a belt is very common. Harley chose not to use shaft drive because it is inefficient in that it robs power from the bike due to friction.


How do you clean an abs sensor?

An abs sensor, can get metal shavings stuck to it, can brake clean, but normally if you have a fault it needs to be replaced.


What might cause and how might you fix the speedometer on your 1992 4Runner which works sporadically and sometimes not at all?

I suspect that you have a bad contact on your speed sensor connector in your transmission. Check connector underneath the car on the driver side, if connector is clean you might need to replace the sensor ( electrical pulse generator ) that's where you plug in the connector...