0
What else can I help you with?
How do you lock the steering on Yamaha vstar 650 classic?
To lock the steering on a Yamaha V-Star 650 Classic, turn the handlebars fully to the left or right, then locate the ignition switch. While holding the handlebars in that position, turn the ignition key to the "lock" position and remove the key. This will engage the steering lock, preventing the handlebars from turning, and help deter theft.
Why does your 2000 F250 start without the key?
The ignition lock seems to be broken.
Where is the ignition switch on a 2004 Pontiac Grand Am?
The ignition switch is immediately behind and attached to the ignition lock cylinder. The ignition lock cylinder is where you place the key to start your vehicle. If you are haveing problems with your vehicle not starting and or turning the key, more than likely you need to replace the ignition lock cylinder. It is common for these to go bad in GM vehicles.
Does a 2003 Honda shadow spirit have a built in helmet lock?
Yes, on left hand side of rear fender there is a lock which is opened with ignition key.
Why wont car start after changing ignition lock cylinder?
It may not be connected right.
How do you install ignition lock in 2003 Chevy S10 pickup?
go to a repair shop they'll tell you
How do you remove a ignition lock 69 camaro z28?
To remove the ignition lock from a 1969 Camaro Z28, start by disconnecting the car battery to ensure safety. Then, remove the steering column cover by unscrewing the retaining screws. Insert the key into the ignition and turn it to the "Run" position; you’ll need to locate and press a release tab or pin on the ignition lock cylinder to pull it out. Finally, withdraw the ignition lock cylinder from the steering column.
The ignition on your car is stuck and you can not start your car?
Is the steering lock on? Jiggle the wheel when you turn the key.
When you turn the key to the start position it only goes to the on position?
Ignition switch lock cylinder
91 Osmobile Cutlass ciera - How to replace the ignition lock?
To replace the ignition lock on a 1991 Oldsmobile Cutlass Ciera, start by disconnecting the negative battery cable to ensure safety. Remove the steering column covers to access the ignition lock cylinder. Insert the key into the ignition, turn it to the "Run" position, and locate the release tab or pin to remove the lock cylinder. Once released, replace it with a new ignition lock cylinder, reassemble the steering column covers, and reconnect the battery.
What could be the problem with a 1998 Oldsmobile Aurora when it does not start up and Security light continues to flash?
The Aurora has a VATS ignition and either the contacts in the ignition lock are bad, the wires from the lock to the computer are broken or the VATS chip in your key is dirty or the contacts in the ignition lock is dirty and not making connection with the chip in the key.
How do you replace an ignition lock cylinder on a Chevy S-10?
Remove the retaining ring at the top of your Chevy S 10 ignition lock cylinder. Slide the ignition lock cylinder out. Remove the wiring harness from the back of the ignition lock cylinder. Reverse the process to install the new ignition lock cylinder.
