answersLogoWhite

0

To lubricate the choke on a 2002 Honda Rancher, first, locate the choke lever and cable. Remove any necessary covers to access the choke mechanism. Apply a light lubricant, such as silicone spray or a penetrating oil, to the cable and pivot points of the choke lever. Operate the choke several times to ensure even distribution of the lubricant, ensuring smooth operation.

User Avatar

AnswerBot

4d ago

What else can I help you with?

Related Questions

What are the torque specs for a Honda rancher?

head torque specs for 2002 honda rancher


How do you change the choke cable on a 2002 honda 350 rancher?

To change the choke cable on a 2002 Honda 350 Rancher, first, remove the seat and right side panel to access the choke assembly. Disconnect the old choke cable from the carburetor and the handlebar lever by loosening any retaining screws or clips. Install the new choke cable by attaching it to the carburetor and the lever, ensuring it is properly routed without any kinks. Finally, test the cable's operation before reassembling the panels and seat.


Will a 2007 Honda rancher engine fit in a 2002 Honda rancher?

not 100% shure but since 2007 is a 420 and 2002 is 350 and the 350 has a carb and 420 fuel injected but if so i might do it to my 06 rancher


How do you set timing on 2002 Honda rancher 350 ATV?

how do i check the timing on my 02 honda 350 atv


Where is the radiator on a 2002 Honda rancher 350 4x4?

in front of the cooling fan


Where can you find a 02 Honda rancher 350 wiring diagram?

This is the whole repair manual that includes the wiring diagram, trouble shooting, and more. It is for a 2000- 2003. I have a 2002 Honda rancher 350 also. See link below:


Where is the front skid plate on a 2001 Honda Rancher TRX 350?

I have a 2002 Honda Rancher 350 and the front skid plate attaches to the brush guard near the bottom. A new one is about $34 for a new one at Motosport.com with about $8 shipping. Hope this helps.


Why is your 2002 Honda rancher es not charging?

Your 2002 Honda Rancher ES may not be charging due to several potential issues. Common causes include a faulty battery, a malfunctioning voltage regulator, or a damaged stator. Additionally, check the wiring and connections for corrosion or damage, as these can interrupt the charging system. Testing the components with a multimeter can help identify the specific problem.


What is the battery size for a 2002 Honda rancher?

The 2002 Honda Rancher typically uses a 12V battery with a size designation of YTX14-BS. This sealed, maintenance-free battery has a capacity of around 12 Ah. It's important to ensure that the battery is compatible with your specific model and any additional accessories you may have. Always consult the owner’s manual for the most accurate specifications.


What is the spark plug gap for a 2002 Honda rancher 350?

The spark plug gap for a 2002 Honda Rancher 350 is typically between 0.028 to 0.031 inches (0.7 to 0.8 mm). It's important to measure and adjust the gap to ensure optimal engine performance and ignition efficiency. Always refer to the owner's manual or service guide for the most accurate specifications.


Where is idle adjustment for 2002 Honda rancher 350?

The idle adjustment for a 2002 Honda Rancher 350 is typically located on the carburetor. Look for a small screw on the side of the carburetor that is marked as the idle adjustment screw. Turning this screw clockwise usually raises the idle speed, while turning it counterclockwise lowers it. Always ensure the engine is warm before making adjustments for optimal results.


How do you start a 2002 Honda rancher 4 wheeler?

To start a 2002 Honda Rancher four-wheeler, ensure the vehicle is in neutral and the kill switch is in the "run" position. Turn the ignition key to the "on" position, then press the start button while squeezing the front brake lever. If the engine doesn't start, check the fuel level and battery condition. Once started, allow the engine to warm up before riding.