I have a Honda 1986 TRX200sx ATV and i am looking at the same thing ive looked online and edelbrock has carburetors but they are all for higher CC's and newer models so i don't know what have you came up with
OR just goto the Honda dealer and buy a jet kit for that model prolly 20-30 dollars..take the carb apart and count the turn out for each jet and right it down replace the jets and float and seat valve needle valve...put back together and good as new!!or you can buy a new 300$$ carb and pay a pro to jet it for you..its your choice,id rebuild it for cheap, its old and id even rebuild with a new ATV
you have to take out the carburetor and then clean it
on the carburetor
try cleaning your carburetor thoroughly
To remove the carburetor from a 350 Honda ATV, first, ensure the engine is off and cool. Disconnect the fuel line and any electrical connections, then remove the air filter and intake boot to access the carburetor. Unscrew the mounting bolts securing the carburetor to the engine, carefully detach it from the intake, and then remove it from the ATV. Make sure to take note of any gaskets or seals for replacement during reassembly.
1500 if its in good shape
Plug one end to the Petcock and the other end to the Carburetor......
The size is 16x8.0x7
check the carburetor and make sure the air cleaner is clean
The carburetor on a Honda FourTrax ATV is typically located on the side of the engine, near the air intake. It is connected to the air filter and the throttle cable, allowing it to mix air and fuel for combustion. To access it, you may need to remove the seat and side panels, depending on the specific model and year. Always refer to the owner's manual for detailed instructions specific to your ATV model.
take it off and have it checked
ATV carberator adjustment 1996 ATV lt4wd
Use Automatic Transmission/Engine Oil for ATV's ONLY! Find it at your local ATV Shop.