It would really be best if you had a manual. Explains step by step. But, once you remove all the extra's, lowers, false tank, wiring, exhaust, lift the carb's, rad., oil, timing belt covers, then you are ready to un-bolt the engine. With a good trolly jack under the engine there is just enough room to slide it out. Job takes about 4 to 5 hours or so and you can have the engine on the floor.
The best way would be to pick up a manual. Just too many things to do.
1980 was the first new version of the Goldwing Interstate. It came with the 1100 engine. That lasted till 1983, then the "84's came out with the 1200, good till 1987, then the 1500's. The 1980 Interstate all dressed cost me just $ 5,000.00 here in Canada, those were the day's.
This bike takes about 3.7 quarts.
I have 1980 Honda Goldwing Interstate with 55,000 on the odometer. I average 45-48 MPG. Jerry Smith Washington Court House, Ohio
'79 is a 1000 cc , '80 is a 1100 cc. You would have to compare the both. Or check with the parts dealer.
10w40 will do just fine. I use Motul.
Two blots one left side and one right side - one may be Allen key. Situated at passenger area of the seat. Paula
The fork oil level for a 1980 Honda Goldwing is typically around 5.3 inches (135 mm) from the top of the fork tube when fully compressed. It's important to ensure the forks are fully compressed and the springs are removed when measuring. Always refer to the specific service manual for your model to confirm the correct specifications and any variations.
You can use any 10-40 W oil that is intended for motorcycles, made for wet clutch use.
Check to see if it is getting power - if so defective motor Run a "Hot" line to motor to see if it starts Check fuses Check sensor at rear of radiator
If this is still the same as up to 1986, then you have to remove the left side exhaust, left side crash bar, gear shift, and removable sub frame. Theres your starter. Good luck.
280.00