Take a look at these videos. http://goldwingfacts.com/forums/forum9/37239.html Basically. Stand on the center stand, so that the bike is standed on both center stand feet. It will then take a gentle rock backwards. The high the Air Shocks the eaiser it is
To properly put a 1800 Gold Wing on the center stand, first ensure the bike is on level ground and in neutral. Stand on the left side, hold the left grip, and press down on the center stand with your right foot while pulling back on the handlebars. Once the stand makes contact with the ground, shift your weight onto the stand and continue to push down until the rear wheel lifts off the ground. Always ensure your body is balanced and stable during the process to avoid tipping the bike.
A reverse gear can be added to a 1985 Goldwing Aspencade. It is best to have it done at a specialty shop that works with older Goldwing's.
To put a BMW K1200LT on its center stand, first ensure the bike is on level ground. Stand on the left side of the motorcycle, then hold the left handlebar and the passenger grab rail with your left hand. With your right foot, press down on the center stand lever while simultaneously pulling the bike upright and back towards you. Once the center stand makes contact with the ground, continue applying pressure until the bike is fully on the stand.
225
The 1200 has a dip stick near the the oil fil cap. Check it while the bike is on the center stand. After unscrewing the dipstick and wiping it off you check the oil level without screwing the dipstick back in. Simply put the dipstick in the hole, remove and check. After verifying the proper oil level, then screw the dipstick back into the engine block
The filler cap is on the right side, lower part of the engine. There is no dip stick. Its a window that you look in, in the same area. On the center stand, look in the window with a flash lite to see the level. If the engine has enough oil in it, then with the engine running, as you look in the window, have someone shut the engine down. You will see the oil level off to be able to see the level.
Yes. Look just under the rad. It has like fins on the casing with just a center bolt. Filter is inside. Watch as you take it out, there is a washer and a spring in ther. Put it back the same way. There is a notch on the engine block to where the housing lines up.
3.9 US quarts for all year 1800's. Just put in a full 4 qts.
First, is this a 1987 1200, last year for 1200's, or is this a 1500, 1988 ? 1987, 1200, fork oil, If you just change the oil without doing a full teardown then 323 cc ( 10.9 oz ) If the fork's have been taken apart for new seals then, 345 cc ( 11.7 oz ) Ask your local dealer for the right oil.
3 1/2 quarts. There is a sight glass on the lower right side that shows the oil fullness.
You Can Put a 1988 Transmission In a 1993 Mustang Body.
it's <center></center>