The shifting sensor on a Honda Rancher 420 is located on the lower, back side of the motor, to the left of the reverse switch. You must remove the skid plate to access it.
the engine oil and trans oil is all in one!
To replace the reverse cable on a 2002 Honda Rancher ES, first, disconnect the battery to ensure safety. Remove the access panel on the rear of the ATV to reach the reverse cable. Detach the old cable from the reverse lever and the transmission, then install the new cable by reversing the disassembly steps. Finally, adjust the cable tension as needed and reassemble the access panel.
were is the oil fiter located at on a 2003 Honda rancher es.
On a 2006 Honda Rancher 350 ES, the reverse sensor is typically located near the rear of the engine, near the transmission. It is usually mounted on the left side and is connected to the wiring harness for reverse light activation. To access it, you might need to remove the left side panel or cover. Always consult the owner's manual for specific details and diagrams.
bike is not shifting
Low battery.
A Rancher ES Should have a lever in the storage compartment to manually shift gears with.
It is a 420cc motor. Such as a Honda Fourtrax "400" is a 400cc.
Put two moth balls inside a FULL tank of gas. Also helps to clean out carb and injectors.
2,500
Take it to your local bike shop