Rebuild kit should come with instructions
Motorcycle carb rebuild kits do not come with instructions.
You should have the service manual for your bike, which covers carburetor removal, dis assembly, reassembly, and re installation. Rebuilding is essentially taking it apart, being very careful to keep everything in order, cleaning everything good, and re assembling. If
you want to install a rebuild kit, just put the part from the kit where it came out of your carb once it's cleaned.
The gas tank and seat must be removed, then the front carburetor and chrome covers on top of cylinder head. there will be small caps that should be held on by two screws; remove and adjust set screw( must adjust to proper specs,check an owners manual or repair manual)
.035 - .038
according to my manual you need 2.5 quarts (u.s.) without a filter change and 3.0 quarts (u.s.) with a filter change....the fram oil filter part is ph6018...
To change the oil on a Suzuki Intruder VS700, first ensure the bike is on a level surface and warmed up slightly to thin the oil. Remove the oil drain plug and allow the old oil to completely drain into a container. Replace the drain plug, then remove the old oil filter using an oil filter wrench, lubricate the rubber gasket of the new filter with a little oil, and install it. Finally, refill the engine with the appropriate type and amount of new oil through the oil filler cap, checking the oil level with the dipstick.