You need to buy a puller ,one for the drive clutch [ on the motor ] and one for the driven clutch .That drives the ATV ! I bought mine from Dennis kirk for 60.00. Take the bolts out of center & put the puller in & tighten puller, they should come off
remove clutch cover. remove old belt. install new belt.
http://www.bikebandit.com/houseofmotorcycles/polaris-atv-sport-400l-w968540-1996/o/m5503
The fuse box on a 1996 Polaris Sportsman 500 ATV is typically located under the front cover, near the battery. You may need to remove the front storage compartment or panel to access it. It contains the fuses for various electrical components of the ATV. Always refer to the owner's manual for specific details and diagrams.
To remove the starter from a 1996 Polaris Explorer 300 4x4 ATV, first ensure the ignition is off and disconnect the battery to prevent any electrical issues. Remove the starter cover and disconnect the electrical connections from the starter. Then, unbolt the starter from its mounting brackets, making sure to keep track of the hardware. Finally, carefully pull the starter out from its housing.
There are no fuses on a polaris ATV.
To change the drive belt on a 2004 Polaris Sportsman 500, first ensure the ATV is on a flat surface and secure it. Remove the left side panel and then the clutch cover by unscrewing the bolts. Slide off the old belt from the clutch sheaves, making sure to note its orientation. Install the new belt by positioning it on the primary clutch and then on the secondary clutch, reassemble the clutch cover, and replace the side panel.
4 ml
polaris
The cylinder compression, for your Polaris ATV, is 14 to 1. The cylinder compression usually decreases as the vehicle gets older.
China.
scrap
Polaris Predator 90