if theres no wheel nuts , then theres a cap over the shaft, remove it and remove the carter pin,
150 lbs?
To unlock the steering on a John Deere LT 150 lawn tractor, first ensure the ignition is off and the key is removed. Locate the steering column and check for a locking mechanism, often a lever or pin that needs to be disengaged. If the steering is still locked, you may need to gently wiggle the steering wheel while attempting to unlock it. Once disengaged, the steering should operate normally.
You cannot download it (as far as I know) but you can purchase the manual (SM 2038) from John Deere ($150) or the CD ($75). Call 800-522-7448 I would recommend the CD (PDF) as you can zoom and print what you want. Good Luck!
10W30 with Turf Guard, which is an additive for high RPM motors. This is only available through a John Deere Dealership, but in a pinch any good quailty 10W30 motor oil will work.
remove wheel ,remove calipers, remove centre bearing nut then slide off disc. be carefull not to drop the bearing in dirt
remove the wheel and and caliper from the wheel and you should be able to beat it right off depending on how many times you have had them rotated cause they will be easier to remove
If you mean the ball joint, there is a tool for that. http://www.sjdiscounttools.com/kdt2287.html
depends on the year and if it has tilt wheel. but regardles you must remove the streering wheel the rest will be no problem
you have to press the wheel studs out of hub after you remove it from the spindle
yes you do, its hard to get to but you should be ale to get to it from there
150 ft/lbs......after rebuild and breakin runs 5,5,10,20 mins and 1 hour....allow to cool completely....loosen headbolts one at a time 5 degrees and retorque to 150 in the correct order
# Raise and safely support the vehicle securely on jackstands. # Remove the brake caliper assembly. # Remove the front disc brake caliper anchor plate. # Remove the hub grease cap. # Remove the cotter pin. # Remove the spindle nut. # Remove the front wheel outer bearing retainer washer. # Remove the outer front wheel bearing. # Remove the hub grease cap gasket. # Remove the front disc brake hub and rotor. # Remove the wheel hub grease seal. # Remove the inner front wheel bearing.