The chain on a 2000 Polaris Trail Boss 325 is removed by loosening the retaining bolts and applying tension away from the sprockets. The chain can them be slipped off the sprockets and removed.
On a 2000 Polaris Trail Boss 325, the fuses are typically located in a fuse box situated under the front panel or near the battery area. To access them, you may need to remove the front cover or panel. Always refer to the owner's manual for specific locations and diagrams. Make sure the vehicle is turned off and disconnected from the battery before inspecting or replacing any fuses.
I think. (but not sure) you can use amsoil series 2000 chain case lube.
2000 polaris magnum 325 2x4
Polaris SnoCross happened in 2000.
Polaris SnoCross was created on 2000-12-27.
the Oregon trail was 2000 miles long.
with a pair of pliers
buy the clymer manual first. there are clips on the inside of the cups remove them press the Ujoint out of the yoke. someone told me you need to install the rear drive shafts with the yokes/u joints the same on both sides lined up. Mine were from the factory. thanks
There are two large bolts -one next to the brake caliper the other next to the chain - simply loosen those bolts and rotate the axle. The chain will tighten up or loosen up depending on which way you turn it.
can some one please help iwant to remove astarter from polaris 425 quad many thanks Hi. If you still need help I recently removed my starter from a 2000 polaris xpedition 425. It's actually quite easy. First remove the seat, then you should be able to pop loose the side panels and remove them. Once you can get in there there should be two bolts holding it to the rest of the engine, and one holding on a positive wire, go ahead and remove those and it should slide out. Mine stuck a bit, but you just have to work with it.
The End of the Trail was created in 2000.
Rodwell Trail was created in 2000.