buy the clymer manual first. there are clips on the inside of the cups remove them press the Ujoint out of the yoke. someone told me you need to install the rear drive shafts with the yokes/u joints the same on both sides lined up. Mine were from the factory. thanks
The chain on a 2000 Polaris Trail Boss 325 is removed by loosening the retaining bolts and applying tension away from the sprockets. The chain can them be slipped off the sprockets and removed.
My 98 polaris trail boss does about 55-60mph
You have to pull the front clutch off to get to the rest of the bolts...
No, it isn't. The Polaris Trail Boss 350 is a liquid cooled 2-stroke.
I have a 1993 Polaris 250 Trail Boss. It won't start. It floods out the carb. Could it be low compression?
1990 vin location for a trail boss 4wd
I can get to 70-80 MPH
take out links
On a 2000 Polaris Trail Boss 325, the fuses are typically located in a fuse box situated under the front panel or near the battery area. To access them, you may need to remove the front cover or panel. Always refer to the owner's manual for specific locations and diagrams. Make sure the vehicle is turned off and disconnected from the battery before inspecting or replacing any fuses.
No, you don't mix oil into the gas of a Polaris Trail Boss 350 4-stroke. It is a 4-stroke engine, and you do notmix oil with the gas.
The location of the fuel filter on a Polaris 330 Trail Boss is in the fuel line that connects to the fuel pump. The fuel pump is located on the driver's side of the motor.
1.9 quarts