To remove the head on a 1987 Kawasaki 300, first, ensure the engine is cool and disconnect the battery. Drain the coolant and remove the necessary components, such as the exhaust pipe and intake manifold, to access the cylinder head. Then, carefully unbolt the cylinder head using the appropriate socket size, ensuring to follow any specific removal sequence to avoid warping. Finally, lift the head off the engine block, being cautious of any gasket material that may need to be cleaned off afterward.
Around 2000 if in good shape
how to adjust cluch for a 1987 bayou
Where is the Oil filter on a 1997 Kawasaki Bayou 300 ATV?" Where is the Oil filter on a 1997 Kawasaki Bayou 300 ATV?"
To remove the seat on a Kawasaki Lakota 300, locate the two bolts or screws at the back of the seat. Use a socket wrench or screwdriver to remove them. Once the fasteners are removed, gently lift the back of the seat and slide it forward to detach it from the mounting points at the front. Ensure you keep the hardware in a safe place for reinstallation.
The Kawasaki dealership would be able to give you the wiring diagram for a 2002 Kawasaki KLX 300. If the dealership doesn't have it on hand, they can order it.
Sounds like dirt/crud in the carb. You need to remove, disassemble, clean and reassemble the carb.
In the Kawasaki KLF 300 Service manual.
top speed of a 300 lakota is around 55mph
The clutch on a Kawasaki Bayou 300 can be adjusted with the use of the 2 adjusting screws. Turn them clockwise to tighten the clutch and counterclockwise to loosen the clutch.
Kawasaki recommends regular 10w 30 for the prarie 300
it shouldn't but it can be done with some new motor mounts and crap.
10w40