under the left side panel
Remove the instrument panel cover. Remove the instrument panel retaining screws. Remove the wiring harness from the gauges. The instrument panel will come out.
remove plastic around instrument panel . remove screws from instrument panel then pull panel towards you to unplug it this will allow to get to dach lights
How do you remove the instrument panel in a 1998 Ford Expedition 5.4 Engine
To remove the instrument panel on a 1987 Mazda B2000, start by disconnecting the negative battery cable to ensure safety. Remove any screws securing the trim bezel around the instrument panel, then carefully pry it off using a trim tool. Next, unscrew the instrument panel itself and disconnect the wiring harnesses at the back. Once everything is detached, you can lift out the instrument panel for replacement or repair.
Remove center stack bezel (radio, heater control), remove screws from instrument trim panel at ctr stack and remove instrument trim panel, remove dash top panel, replace speakers.
To remove the instrument panel on a 2007 Skoda Octavia, first, disconnect the car battery to ensure safety. Then, carefully remove the trim surrounding the instrument cluster using a trim removal tool to avoid damaging the dashboard. Unscrew the screws securing the instrument panel, typically located at the top and sides, and gently pull the panel out. Finally, disconnect any electrical connectors before fully removing the instrument panel.
remove the trim panel around the instrument cluster then remove cluster. On the back of instrument cluster are the bulbs just turn them half a turn and they come right out.
To remove the instrument panel from the 1998 Mitsubishi Eclipse, carefully pull back the pod. Take care not to lose any of the clips.
To remove the instrument panel on a Peugeot 106, start by disconnecting the car battery to prevent any electrical issues. Next, carefully pry off the trim surrounding the instrument panel using a flat tool, and remove any screws securing the panel in place. Once the screws are out, gently pull the instrument panel forward, disconnecting any electrical connectors attached to it. Be cautious not to force it, as this could damage the panel or connectors.
with a hammer
Remove the instrument panel cover retaining screws. There are four screws that need to be removed. The instrument panel light bulb's will be visible. Push the light bulb in and turn at the same time to remove the light bulb.