answersLogoWhite

0

What else can I help you with?

Related Questions

How much oil goes into a 1991 kawasaki ninja zx6?

3.7 liters


Where can one find more information about ZX6?

A ZX6 is a motorcycle which is manufactured by the Kawasaki company. Information on the ZX6 can be found on the Kawasaki website or by visiting a local Kawasaki dealer.


Loud tick noise in the engine block 94 kawasaki ninja zx6 Has anyone had this problem?

It could be your Cam tensioners. I have it on my 1998 Zx6r. It goes away after riding a bit.


Can kawasaki zx6 1991 run on unleaded fuel?

yeh derrr


How many quarts of oil are needed for a 1994 kawasaki zx6?

3.1415927


What model kawaskai is the engine number zx600EE?

Is the 95 Kawasaki ZX600 ZX6 motorycle Engine number ZX600EE 066029 and "E"motor or an "R" motor? What model kawasaki is it? I have a 95 Kawasaki ZX6 with engine number ZX600DE065150. Are these 2 engines the same?


Where do you find a free service manual and wiring schematic for a1990 kawasaki zx6 motorcycle?

An additional service manual and wiring schematic for an A1990 Kawasaki ZX6 motorcycle can be found on eBay as well as at specialty motorcycle dealerships.


How do you set the timing on a 1990 kawasaki ninja zx6?

To set the timing on a 1990 Kawasaki Ninja ZX6, first ensure the engine is at top dead center (TDC) on the compression stroke for cylinder one. Then, align the timing marks on the ignition rotor and the case, adjusting the ignition timing if necessary using the timing adjustment screw. Finally, check the timing with a timing light while the engine is running to ensure it’s within the specified range. Always refer to the service manual for specific timing specifications and adjustments.


How fast is a kawasaki ninja zx 6r?

I have not took my zx6 to extreme yet but i took it up to 160 and lost my helmet LOL but it was still willing to have more throttle power and also felt like it was capable of getting to the 220 mark.


How do you remove the ignition switch on a 1994 kawasaki zx6 ninja?

Most motorcycle ignitions have whats called a "shear bolt" I think, they're designed to "shear" off the hex portion of the bolt when installing the ignition. This prevents theft. Usually to remove the cone type bolt the best way it to use a steal center punch and hit the head of the bolt to turn it counter-clockwise to loosen it. If it is too tight to loosen this way unfortunately the only other option I know of it to drill the bolt out. Good Luck. MotoMedix Ottawa.


Zx6 fuel pump?

what is the question


How do you adjust the timing chain on your zx6?

you don't adjust, you replace