0
What else can I help you with?
How do you change the choke cable at the handle bars on a arctic cat 400 atv?
To change the choke cable on an Arctic Cat 400 ATV, first, ensure the ATV is turned off and secure it. Remove the handlebar cover and locate the choke cable connection, then unscrew and detach the old cable from the choke lever. Install the new choke cable by threading it through the handlebar and securing it to the choke lever, ensuring it operates smoothly. Finally, reassemble any removed parts and test the choke function before use.
How do you remove speedometer 70 dodge dart?
remove cable from the transmission and remove the cable from the back of the speedometer up under the dash and then the complete cable can be pulled out.
How do you replace a speedometer cable for a 1978 Chevy silverado?
Remove speedometer head to unscrew and remove cable Remove cable from transmission Re-Install new cable using same routing as original
Who should I call to remove old cable lines?
You should contact your cable service provider to remove old cable lines.
How do you remove or lift the seat from a 300 prairie 300 4 wheeler?
The seat is removed using a pull ring behind the seat, under the rear fender and taillight. It is a cable with a loop in it. Pull the loop, lift the seat.
How do you replace a battery in a 1996 Buick regal?
Remove - battery cable Remove + battery cable Remove hold-down bolt on front bottom of battery tray Remove battery
How do you change battery in 2004 gmc sierra?
1. Remove negative battery cable 2. remove positive battery cable 3. remove battery 4. install new battery 5.attach positive cable 6.attach negative cable
Install speedometer cable in 1953 Chevy?
Remove speedometer head Disconnect old cable Follow original routing for new cable Disconnect fitting at side of transmission and remove cable - replace with new
How do you remove the clutch cable on a 1996 Chevy s10?
There is no cable, it is hydraulic operated.
How do you replace kick down cable on 1972 c20 turbo 350?
You have to drop the trans pan to do it. Remove the cable from the carb and bracket. There is one bolt where the cable runs into the trans. Remove that bolt. After dropping the pan you'll see how the cable is mounted inside the trans. Remove the retaining clip and pull the cable out. Reverse for installation.
How to remove clutch cable for a 2006 wide glide harley?
1. Take the tension out of the cable by loosening the adjustment on the cable. 1/2" and 9/16" wrench required. 2. Take the Allen screws out of the right side transmission cover. (may have to remove exhaust to do so. 3. Remove C-clip holding clutch mechanism inside the trans cover. 4. Remove cable from clutch mechanism and unscrew cable from trans cover. 5. Remove pin on handlebar lever and remove cable from lever. To install reverse removal instructions ***Note*** Be careful when threading new cable into trans case. DO NOT over tighten you will break the new cable
How do you remove shift cable on a 2000 cavalier z24?
Remove the air intake box and look beneath the master cylinder and you will see the shift cable. unbolt it from the transmission using the appropriate socket and undo the shift cable. on the inside, remove the center console and undo the cable inside as well
