Take the rotor and the clutch basket off at the same time
Remove the Seat.
remove the round derby cover from the primary. fill until the oil tries to run out. replace the cover.
how to remover oil tank 1988 sportster
locate and remove your primary oil drain plug, once the fluid is removed,remove the derby cover and replace the primary fluid to the approiate level
There is a Hose with a Clip attached to the Left Side of the Frame underneath the Primary Cover. Remove the Clip and Pull the Drain Plug in the Hose..
remove one at a time follow it to where it goes and pull it off and do the same with the other one. this is very easy no tools needed
On a 1986-2003 there is a drain hose. Look under the motor and there is a rubber hose with a worm clamp on it, it attaches to a bung on the frame. Loosen the clamp and remove the hose from the bung.
On my 06 I just removed the two nuts & bolts on each side & slid it out.
good instructions in the manual. I just removed mine to have it welded.
To remove the fuel injectors on a 2009 Harley Sportster, first ensure the bike is cool and disconnect the battery. Remove the fuel tank and the air cleaner assembly to access the injectors. Then, carefully disconnect the electrical connectors and fuel lines from the injectors. Finally, unbolt the injectors from the manifold and pull them out, taking care to avoid damaging any surrounding components.
To remove the side panel on a 1990 Harley Sportster, locate the screws or bolts securing the panel, typically found at the bottom or back. Use a screwdriver or appropriate socket tool to remove these fasteners. Gently pull the panel away from the frame, taking care not to damage any clips or wiring. Ensure you handle the panel carefully to avoid scratches or dents.
Next to your battery you will see a triangle shaped cover with 3 screws in it, remove that to access wiring, fuses, etc.