Wait for engine to be fully cooled down. Take a magnet on a wand & #2 Phillips screwdriver and remove lock screw from radiator cap. Turn radiator cap counter clockwise until it rises into a loose position and lift it off.
1
40 to 50 mph's depending on conditions [highway verses city]
Remove the water from the radiator. Remove the radiator hoses. Remove the stabilizing arm from the top of the radiator. Remove the radiator retaining bolts. Reverse the process to install the new radiator.
Drain the water from the radiator. Remove the radiator hoses. Remove the radiator stabilizing arm. Remove the radiator retaining bolts. Reverse the process to install the new radiator.
Remove the plug at the bottom or the rear of the radiator or remove the lower radiator hose
Remove the lower radiator hose.
Its @ the bottom of radiator kinda n da middle of it.
On a 1998 Honda Valkyrie motorcycle, the fuse panel is typically located under the seat. To access it, you'll need to remove the seat by unscrewing the bolts or fasteners that secure it. Once the seat is removed, the fuse panel should be visible, allowing you to check or replace any blown fuses. Always refer to the owner's manual for specific instructions and fuse specifications.
How do you remove the front axle on 1998 Honda 450 foreman?Read more: How_do_you_remove_the_front_axle_on_1998_Honda_450_foreman
usually at the bottom or rear of the radiator - or remove the lower radiator hose
How hard is it to remove and is there a digram procedure available on-line to remove it.
Remove upper radiator support remove bolts that retain the A/C condenser remove hoses and transmission cooler lines remove retaining bolts then remove fan module and lift out radiator