answersLogoWhite

0

Put the bike on the center stand. Loosen the rear axle nut, remove the bolt and the spacer, then bring the caliper assembly out of the way and suspend it by a wire or thin rope. Next, take hold of the wheel and slide it off and away from the final drive. The rear wheel should now slide off the spline of the final drive. Too much air in the tire may prevent it from sliding easily past the final drive so let air out in that case. Coat the spline of the final drive with grease or a Moly 60 paste upon reassembly.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How do you remove the front axle on 1998 Honda 450 foreman?

How do you remove the front axle on 1998 Honda 450 foreman?Read more: How_do_you_remove_the_front_axle_on_1998_Honda_450_foreman


On a 1982 Honda goldwing where is the speedometer cable located?

Look at the left side of the front axle. There should be a cable running there between the lower leg of the fork and the hub of the wheel. That's the speedometer cable. The other end should be connected to the back of the speedometer.


How do you remove the front axles on a 1993 Honda Civic?

Begin by removing the tire and wheel from your 1993 Honda Civic. Remove the brake assembly and the brake rotor. Remove the axle retaining bolts. The axle will come off.


How do you remove a front axle on a Honda 420 rancher 4x4?

How do you get the axle out to change the boots on the cv joints


How do you Remove a left rear axle on Honda 2002 350 es 4X4?

There's only one axle...not a left and right. Buy a Honda service manual before you tare it up.


How do you disassemble the rear axle on a 2000 Honda TRX 300?

In order to dissemble the rear axle on a 2000 Honda TRX 300 first determine if it is inner or outer joint. You then remove the retaining ring behind the boot to access the axle.


How do you remove a rear axle on a Honda Rincon?

There is a complete walk through in the related links section.


How do you remove front axel on 1985 Honda ATV big red?

To remove the front axle on a 1985 Honda ATV Big Red, first, lift the front of the ATV and secure it on jack stands. Remove the wheel nuts and take off the front wheels. Next, disconnect the brake caliper and any other components attached to the axle. Finally, remove the axle nut and slide the axle out of the hub, taking care to support any remaining components as needed.


What size is axle nut on 1982 dodge rampage?

The axle nut for the 1982 Dodge Rampage is the size ofÊ2-9/16. You need to know the exact size in order to get a socket to remove the nut.Ê


How do i remove a Honda rincon ATV rear axle?

Check out the related links for a walk through guide.


How do you remove the front axle on a 2004 Honda shadow 600 vlx?

To remove the front axle on a 2004 Honda Shadow 600 VLX, start by securing the motorcycle on a stable stand. Loosen the axle pinch bolts on both sides of the front fork, then use a socket wrench to remove the axle nut on one side. Slide the axle out from the opposite side, ensuring that the brake caliper and wheel are supported during the process. Finally, carefully detach the front wheel from the forks.


How do you change the front axle on a 1998 Honda civic?

jack up car remove wheel remove axle nut take bottom 19mm bolt loose and 14mm loose from horseshoe remove horseshoe separate spindle from lower ''a'' arm pull Axle out of spindle remove from trans to replace reverse process