To remove the seat from a 1989 Yamaha four-wheeler, first locate the seat release mechanism, which may be a latch or bolts, depending on the specific model. If it's a latch, pull it to release the seat; if it’s bolts, use the appropriate tool to unscrew them. Once released, gently lift the seat from the frame, taking care not to damage any attached components. Always refer to the owner's manual for specific instructions related to your model.
remove two bolts under seat pivot for gas filler neck then slide seat back and lift up. that's it.
A person can remove the seat on Yamaha BW350 motorcycle by depressing the release under the edge of the seat. The seat can then be raised and removed from the bike.
The Yamaha 1200 motorcycle seat is held in place by four retaining bolts. Remove the retaining bolts and the seat will come off.
The seat on a Yamaha BW80 motorcycle is removed by taking out the retaining screws under the lip of the seat. It can then be raised up and detached from the hinges.
Remove a bolt (hex) from either side at the bottom of the seat. Near the shock.
Remove the 10mm bolt from behing the rear seat. Then pull the rear seat it hooks to the front seat in the front. Remove the bracket there and pull the front.
key unlocks top section(pillion) which exposes nuts at the rear of main seat. unscrew and slide seat backwards, this will remove the seat.
Yes, you may remove the back seat saddle bags and visor from a 1988 Yamaha. You will need to unscrew the bolts attached to the back seat and visor.
You can remove the off a Suzuki 230 4 wheeler by locating the mounting bracket on the floor of the vehicle. Once you find that, you can remove the screws in the plate with a Phillips head screw driver, and take the seat out.
To remove the seat on a Yamaha Vino, locate the seat latch under the rear of the seat. Pull the latch upward while simultaneously lifting the back of the seat. Once the latch is released, the seat will detach from its hinges, allowing you to remove it completely. Be sure to check for any additional fasteners or clips if applicable, depending on the specific model year.
To remove the seat on a Yamaha 350 Big Bear, locate the seat release mechanism, which is typically a latch or bolts at the rear of the seat. For models with bolts, use a wrench to unscrew them. For latch mechanisms, pull the latch up or slide it to release the seat. Once the latch or bolts are disengaged, lift the seat off the frame to remove it.
remove bolt on the back of passenger seat, pull that back and out. Then driver seat just pulls back and out as well.