answersLogoWhite

0

put your key into the helmet holder and unlock it then pull down on the latch attached to the helmet holder and lift the seat up

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you remove the seat from a 2006 HONDA CBF 250?

The 2006 Honda CBF 250 seat is held in place by four retaining bolts. Remove the retaining bolts to remove the seat.


How do you remove seat Honda Rebel 250 2005?

You have to remove the 28 mm bolts at the rear of the passenger seat on either side of the tail light. Now slide the passenger seat back to release a clip holding the front edge of the passenger seat. Then remove the 12 mm bolts holding the seat to the frame.


How do you get to the battery on a Honda rebel 250?

Take off the seat


Where is the spark plug on a Honda crf 250?

If you remove your seat, then remove your gas tank and radiator shrouds, then theres a black rubber coil going into the front/top of the motor remove that. then bam spark plug


Will a 1989 Honda cr 250 crankshaft work in a 1990 Honda cr 250?

Yes, it will fit and do fine! 1986 - 1991 are the same cranks.


How do you take a battery out of a 86 Honda 250 atc?

Pull off the seat, its under there.


Where is the 1988 Honda cbr 250 battery?

If you're asking where the battery is on the bike. On my CBR 250 Hurricane it's under the seat, but you have to take off all the back seat and side panels to get the seat off which is a pain.


Is there a performance variator for the 1990 Honda Elite 250?

yes malossi multivar 2000 #5111262


How do you remove the seat on eliminator 250?

On an '89, remove both side covers and you will see a bolt on both sides of the bike just under the seat. Remove the bolts, lift the back of the seat and slide toward the rear of the bike.


How do you remove driveshaft from 8687 Honda 250 fourtrax?

take the boult off the bouttom of it


How do you remove seat from 2003 ktm 250 sx?

To remove the seat from a 2003 KTM 250 SX, start by locating the bolts at the back of the seat. Use a socket wrench to unscrew them, then lift the rear of the seat upwards. Once it’s free from the rear mounts, slide the seat forward to detach it from the front hooks. Make sure to keep the bolts in a safe place for reinstallation.


Where is the governor on a Honda nighthawk 250?

There's no governor on a Honda Nighthawk 250. A Honda 250 Nighthawk is a motorcycle, not a lawnmower.