On an '89, remove both side covers and you will see a bolt on both sides of the bike just under the seat. Remove the bolts, lift the back of the seat and slide toward the rear of the bike.
The 2006 Honda CBF 250 seat is held in place by four retaining bolts. Remove the retaining bolts to remove the seat.
To remove the seat from a 2003 KTM 250 SX, start by locating the bolts at the back of the seat. Use a socket wrench to unscrew them, then lift the rear of the seat upwards. Once it’s free from the rear mounts, slide the seat forward to detach it from the front hooks. Make sure to keep the bolts in a safe place for reinstallation.
You have to remove the 28 mm bolts at the rear of the passenger seat on either side of the tail light. Now slide the passenger seat back to release a clip holding the front edge of the passenger seat. Then remove the 12 mm bolts holding the seat to the frame.
put your key into the helmet holder and unlock it then pull down on the latch attached to the helmet holder and lift the seat up
If you remove your seat, then remove your gas tank and radiator shrouds, then theres a black rubber coil going into the front/top of the motor remove that. then bam spark plug
there are two bolts in the back of the seat. remove them and then slide the seat back about an inch and remove
To remove a bike seat, locate the bolt underneath the seat and use a wrench to loosen and remove it. Once the bolt is removed, the seat can be taken off by sliding it out of the seat post.
To remove the back seat of a 1998 Toyota Corolla, you will need to remove the carpet to expose the bolts for the seat. Then, loosen the bolts by removing the nuts. You can then remove the seat.
On newer models, you have to move the seat all the way forward, remove side trim cover, remove seat belt anchor bolt, remove seat rails retaining bolts, tilt seat upward, disconnect wires, remove seat...
You do not charge a battery using a battery eliminator. The eliminator is not a charger, it is an eliminator that allows you to run the device.
The bolts are visible at the base of the seat. Remove them and lift out the seat.
you must remove the bolt behind the rear seat and remove the rear seat then you will see 2 small Allen head bolts remove them and the seat will come right off.