Get a shop manual. remove primary cover and primary chain. Remove rotor. Unplug stator from voltage regulator. Remove stator. Reverse process to install. You will need a manual and an impact wrench... at very least.
Remove the cables from the 1995 Harley-Davidson Road Tank motorcycle starter. Remove the retaining bolts. Reverse the process to install the new starter. The starter turns the engine over so it can start.
Follow directions in manual for your model.
To do this, you must have the manual.
is the stator ,under small round cover on egine.
To test the stator on a 1994 Harley Davidson Wide Glide, first, disconnect the battery and remove the stator cover. Use a multimeter to measure the resistance between the stator's three yellow wires; it should typically read between 0.1 to 0.5 ohms. Next, check for continuity to ground by measuring resistance between any yellow wire and the stator case; there should be no continuity. If the readings are outside these ranges, the stator may be faulty and should be replaced.
Of course you can.
remove the seat
The Alternator which is also called a Stator is located inside the primary case. You will have to remove the primary coverand the primary chain. The Stator is bolted to the engine at the crankshaft.
A Harley Davidson Ultra can be purchased from a Harley Davidson dealership. On their website you can locate the nearest Harley Davidson dealership to you.
One can purchase a Harlet Davidson GPS from Preston-Harley Store, New Castle Harley-Davidson and Warrs websites. One can also purchase it from Chester-Harley-Davidson and Harley-Davidson.
how do i replace the bendix drive in my 85 harley fxrs
EVOEvolution Engine (Harley-Davidson Motorcycles)