answersLogoWhite

0

Pull the motor apart and put sand in the top of the piston and add water put back together and fill gaps with expanding foam before u start it

make sure u place water in fuel tank before starting and start it run till it turns off

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you put rings on piston 125 Yamaha breeze?

To install piston rings on a Yamaha Breeze 125, first ensure the piston is clean and the rings are oriented correctly, with the marking or gap positioned as specified in the service manual. Gently compress the rings using a ring compressor or your fingers to fit them into the piston groove. Carefully insert the piston into the cylinder, ensuring the rings do not get pinched or damaged. Once the piston is in place, you can proceed with reassembling the rest of the engine components.


How do you repair Saturn SL2 piston rings?

You don't. The only solution to damaged piston rings is to take the engine block out of the car and replace the rings.


How much is it to replace the piston rings?

How much does a car cost?


How do you replace piston rings on a Suzuki FA50?

you bring it to a shop


How do you fix piston rings?

you don't fix piston rings. if you have bad rings you have to pull the piston and replace them. on most vehicles you have to pull the engine, then you take off the heads and oil pan. unbolt the caps from the bottom of the rod and push it out the top.


How do you replace the piston rings on a 1999 Saturn SL2?

If you are mechanically inclined it is cheaper to replace the entire engine


What does a rebuild of a top end on a Yamaha warrior?

Resleeved,New piston, rings, wrist pin, Valve springs and seals


Why there is rings in piston?

The piston rings create a seal between the piston and the cylinder wall.


How do you replace piston rings on a 2000 pontiac montana?

There's no point in replacing the piston rings. You have to completely remove and disassemble the engine in order to reach the rings. In light of the fact that you didn't know this, you should have the ENGINE replaced by a qualified technician.


Can you replace rings in your mustang engine is 302.is it possible to pull oil pan remove rod bolts push piston to top of engine to replace rings putting on new heads anyway so access to top of piston?

Yes, just be careful not to scratch the crank journals with the studs on the piston rod.


How do you replace rings on lawn mower?

To replace the piston rings, you will nee to use a ring compressor tool or two pliers to remove the old rings. Place on the new rings, and scatter the gaps in the rings. Apply some engine oil to the rings so they are easier to get in place.


How do you fix a Yamaha ATV that doesnt have any compression?

rebuild top end (NEW RINGS, MAYBE PISTON, AND HONE OR BORE CYLINDER)