When a system with a water-cooled condenser cycles off, the water regulating valve should
When a system with a water-cooled condenser cycles off, the water regulating valve should
you take the head off and take all the valves off
no
Remove motor from bike. Take head off the motor replace gasket .If it has an over head cam make sure you put motor to top dead center. Then take out cam and tie chain up so it will no fall down. If it is liquid cooled make sure you drain it before you take the motor out.
because water is vapourised and then cooled so water is inside
the water molecules are getting cold
You would add coolant (not water) to the vehicle's reservoir when it is off and cooled down. Fill it to the cold line.
No. The valve springs can remain on the head when removing the head.
You don't. You have to take the mesh off first. Maybe you can spray the mesh with a waterproof spray but I doubt it will work. To dye a lax head the water has to be hot. Hot water will take off any spray or wax that you put on the mesh.
the head has ten bolts and you half to take them off first you hafto take the timing belt off and then the water and oil.take the thming brakit off and the top timing gear you can pull off the headnow put on new head with gaskit don't scrach the surfice!!!!!tightin new head bolts to like (95fps)or more make shour to youse new head bolts.
yeah