0
the head has ten bolts and you half to take them off first you hafto take the timing belt off and then the water and oil.take the thming brakit off and the top timing gear you can pull off the headnow put on new head with gaskit don't scrach the surfice!!!!!tightin new head bolts to like (95fps)or more make shour to youse new head bolts.
What else can I help you with?
How do you replace the water pump on a 1993 Pontiac Sunbird SE V6?
remove belt pump is accessable remove bolts make sure coolant is drained first replace
How do you replace the water pump on a 1993 Pontiac Sunbird 4 cylinder?
Check autozone.com it tells a bit about it. some engines you have to remove the timing belt so its not a very east job.
How do you replace a oil pump on a 1993 Pontiac sunbird?
To replace the oil pump on a 1993 Pontiac Sunbird, first, ensure the engine is cool and disconnect the battery. Drain the engine oil and remove the oil pan by unbolting it carefully. Once the pan is off, remove the old oil pump by unbolting it from the engine block, then install the new pump, ensuring proper alignment. Reassemble by reversing the steps, replacing the oil pan, refilling with oil, and reconnecting the battery.
Spark plug cap for a 1993 Pontiac sunbird?
0.045
Tire size on a 1993 Pontiac sunbird LE?
14"
Does someone have a fuse diagram for a 94 ford sunbird?
1993 Pontiac Sunbird Fuse Box Map
What does LE stand for on a 1993 Pontiac Sunbird LE?
limited edition
How do you replace the ignition on a 1993 Pontiac sunbird?
To replace the ignition on a 1993 Pontiac Sunbird, first disconnect the negative battery cable to ensure safety. Remove the steering column covers to access the ignition switch, then detach the wiring harness and unscrew the ignition switch from the column. Install the new ignition switch by reversing the process, securing it in place, reconnecting the wiring harness, and replacing the steering column covers. Finally, reconnect the battery and test the ignition to ensure it works properly.
What is the oil capacity of a 1993 Pontiac sunbird 4 cylinder?
4 quarts
What is torque sequence for heads on 1993 Pontiac sunbird?
A 1993 Pontiac Sunbird head bolt torque sequence recommends starting at one and of the head and alternating to the other end of the head. You should end up in the middle.
Where is the thermostat located on a 1993 Pontiac Sunbird v-6?
On a 1993 Pontiac Sunbird with a V6 engine, the thermostat is located in the engine block, specifically at the end of the upper radiator hose. To access it, you typically need to remove the upper radiator hose and the thermostat housing, which is secured by bolts. Once the housing is removed, you can replace the thermostat itself. Always make sure to consult a repair manual for specific details and safety precautions.
How do replace a starter on a 93 Pontiac sunbird?
To replace the starter on a 1993 Pontiac Sunbird, first disconnect the negative battery cable to prevent electrical shorts. Then, locate the starter, which is typically found near the transmission bell housing, and remove the mounting bolts. Unplug the electrical connections from the starter before taking it out. Finally, install the new starter by reversing the removal process, ensuring all connections are secure before reconnecting the battery.
