Look at the ignition key. You remove the seat by turning the key without pushing down on the key to the seat removal location. It says where to turn it to. The seat should then pop up a little in the front.
take bolts out at front left and right side then slide entire seat forward and lift off
Take the key to motorcycle, insert it in the seat lock on the left side of the motorcycle, under the seat cowl, unlock lock, lift seat up and pull seat out.
two bolt under the front seat left side and right side. they will be a metric Allen head
Under the tail of the quad on the left side there's a release lever. Pull it and seat will loosen then take it off
Total amount 2.3L
pull the seat base out and then you will see 2 bolts that hold the seat back down to the floor, take the bolts out and the back will come out.
Remove seat take left side plastic off and bingo there ya go
To remove the seat on a Yamaha FZ6R, locate the seat release mechanism, which is typically found under the rear of the seat. Use a key or flathead screwdriver to unlock the latch, then pull the seat upward from the rear and slide it off the mounting hooks at the front. Ensure you also check for any additional bolts or fasteners if applicable. Always refer to your owner’s manual for specific instructions related to your model.
Under the seat accessible on the right side after you take off the cover. (by simply pulling with your fingers.)
Remove the screw on the panel below the front of the seat. Then open the seat and remove the two Phillips type screws near the seat hinge. Then remove the panel below the front of the seat and have a look. You can also take the storage container right out if you want to get in deeper.
You take that thing called a seat belt and plug it into the other part .
there are bolts that are underniether the seat which you need to use a ratchet to take the seats out its held in by four bolts i believe