Overhead cam (OHC) valves in a motorcycle engine are part of the valve train system that controls the intake and exhaust of air-fuel mixture and exhaust gases. In an OHC design, the camshaft is located above the valves, allowing for more precise timing and better performance compared to pushrod systems. As the camshaft rotates, its lobes push directly on the rocker arms or the valves themselves, opening and closing them at specific intervals during the engine cycle. This design helps improve engine efficiency, reduce weight, and enhance overall power output.
Begin by removing the cover to the valves. Each valve will have an adjustment screw. Turn the adjustment screw to adjust the valves in your 1972 motorcycle.
Worn engine rings or valves Worn engine rings or valves
No. ***Dual ohc means there are 2 camshafts on the vehicle also meaning more valves
ohc
some have, for example, TVS star motorcycle from India. James Kironde
why would a speedometer and odometer not work on a suzuki motorcycle?
using valves
A camshaft is driven by a linkage from the crankshaft, and operates your valves; directly in an OHC setup, and via pushrods otherwise. Cam "follower" is just an updated "roller bearing" for a camshaft.
Half the car length before engine damage
it wont have valves in the head. If you remove the exhaust pipe from the head and turn over the engine by hand, there will only be a piston and no valves moving.
overheadcam
The Honda S90 or Honda Sport 90 or Super 90 was a 90 cc Honda motorcycle. It had a single cylinder OHC air-cooled engine linked to a four speed transmission.