answersLogoWhite

0

This is caused by the needle and seat not closing off the flow of fuel. The gas gets into the cylinder, fills it up, and when you turn the engine over it compresses the gas. This forces the gas to work its way around the end gaps in the rings and into the crankcase (and oil).

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What is the oil viscosity of a Yamaha grizzly 660?

10W40


What is the oil capacity for a Yamaha Grizzly 660?

2.6 US QTS


How much oil does a 1998 grizzly 660 4 wheeler take?

Has this been answered?


How much oil do you pu in a Yamaha grizzly 660 ATV?

It says 2.6 QTS


How do you change the oil on your 660 Grizzly?

first u put a jack under the back of your grizzly 660 the oil tank is on the bottom and find the drain plug but before u unscrew the plug put it back down if you do not put it back down you will not get all the oil out and then unscrewand and empty


What type of oil for 2004 Yamaha grizzly 660?

the oil that is usually for grizzly is 10w30 but to make sure take your seat off and read the label on your breather it shold be listed under liquids


How do you fix a 2003 Yamaha 660 Grizzly that has gas in the oil Do I have a blown engine?

no the motor isn't blown.the head gasget is blown.change it then it should be fine.but don't forget to change the oil.after you change the head gasget.ok i hope this helps you out.


What if no oil is getting to the motor on a 2001 Yamaha raptor 660?

sounds like the oil pump went out


Where is the oil filter located on a Yamaha grizzly 660?

The oil filter is located at the back of the Yamaha but be careful because you could seriously injur yourself when trying to change the filter of the oil because it's bad.


What is the differential oil capactity for a Yamaha grizzly 660?

front or rear diffs take approximately 320cc. fill the diffs till the oil runs out the filler hole, it will find its own level.


How do you change rear differential oil grizzly 660?

To change the rear differential oil on a Yamaha Grizzly 660, first ensure the ATV is on a level surface and secure it with a block. Remove the drain plug from the rear differential and allow the old oil to completely drain out. Replace the drain plug, then remove the fill plug and use a funnel to add the recommended differential oil until it reaches the fill hole. Finally, replace the fill plug and check for any leaks.


Where do you check the transmission 0n a 2005 Yamaha grizzly 660?

To check the transmission fluid on a 2005 Yamaha Grizzly 660, locate the transmission oil dipstick, which is typically found on the right side of the engine. Remove the dipstick, wipe it clean, and reinsert it to check the fluid level. The fluid should be at the proper level indicated on the dipstick. If necessary, add the appropriate transmission oil through the dipstick tube.