The original parts had no grease fittings.
0.070
Zero from the factory.
It wasn't built with any.
1998 the 10th charicter represents the year model W means 1998
2 quarts. Don't forget to drain the crankcase too.
Not with original equipment. Some replacement parts may have.
they are everywhere...any where there is a joint or working, encased, parts.
Yes, there are only grease fittings on the lower control arm ball joints one each side. It seems that some were delivered with these grease fittings and some just had thread plugs instead.
It had zero from the factory. Aftermarket steering or suspension components could have them.
On a 1998 Jeep Cherokee Sport, the grease fittings, also known as zerk fittings, are typically located on the front suspension components, such as the upper and lower ball joints, tie rod ends, and the steering linkage. Additionally, there may be fittings on the U-joints of the driveshaft. It's important to consult the vehicle’s service manual for specific locations and maintenance recommendations.
On a 1998 Chevy Silverado, the grease fittings, also known as zerk fittings, are typically located on the front suspension components. You can find them on the upper and lower ball joints, tie rod ends, and sometimes on the steering linkage. Additionally, there may be fittings on the U-joints of the driveshaft. It's important to check your vehicle's service manual for specific locations and maintenance recommendations.